Vehicle Specific Console Installation Instructions

ManualsBrandsHavis-Shields ManualsAutomobile PartsFord F-450

INSTALL INSTRUCTIONS C-VS-0309-F250

VEHICLE SPECIFIC CONSOLE

1999-2007 FORD F-250, 350, 450, 550

TOOLS REQUIRED:

Ratcheting wrench

Sockets Set

Cutting tool (if necessary)

Screwdriver set

T-20 torx bit

HARDWARE:

QTY DESCRIPTION PART #

2 ¼” x 1 ¼” Hex head bolt GSM33003

2 ¼” Flat washer GSM31005

2 ¼” Serrated nut GSM30023

4 #8 x ¼” Phillips flat head sheet metal GSM33178

1 Torx Screw kit C-HK-1

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use hardware provided with install kit

 For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call

1-800-524-9900.

Summary of content (4 pages)

PAGE 1
4 INSTALL INSTRUCTIONS C-VS-0309-F250 VEHICLE SPECIFIC CONSOLE 1999-2007 FORD F-250, 350, 450, 550 TOOLS REQUIRED: Ratcheting wrench Sockets Set Cutting tool (if necessary) Screwdriver set T-20 torx bit HARDWARE: QTY DESCRIPTION 2 ¼” x 1 ¼” Hex head bolt 2 ¼” Flat washer 2 ¼” Serrated nut 4 #8 x ¼” Phillips flat head sheet metal 1 Torx Screw kit PART # GSM33003 GSM31005 GSM30023 GSM33178 C-HK-1 Always! Read all instructions before installing any Havis-Shields Equipment Corp products.
PAGE 2
View of Ford F-Series dashboard Remove upper portion of dashboard as shown above Remove enough to expose hex screws holding lower portion of dashboard Remove (2) upper hex screws located under the upper portion of the trim.
PAGE 3
Remove two hex screws on each side of cup holder bracket Remove (2) screws on lower side of lower trim panel. The insert this screw attaches to will be removed. See later instruction. Remove (2) hex screw as shown above. Notice location. Remove lower trim panel Remove plugs on optional brake control switch. (If necessary) Remove brake control switch from lower trim panel. This will reinstall into console.
PAGE 4
Remove this screw clip to allow a ¼” bolt to fit into this hole Attach lower portion of console using ¼” x 1 ¼” hex bolt, washer and serrated nut Complete installation of C-VS-0309-F250 console Complete installation of C-VS-0309-F250 console w/ accessories (Sold separately) -Brake controller/Aux Switching equipment bracket (C-EB30-F50-1P) -Mic Clip Bracket (C-MCB w/ C-MC) -Cup holder (C-CUP2-E-C with additional “L” bracket # CM93086 ) 4 C-VS-0309-F250_INST_4-07