Ratcheting Wrench Installation Instructions

C-TCB-31-INST-1-07
INSTALL INSTRUCTIONS C-TCB-31
2004-2007 FORD F-150 (EXCLUDING HERITAGE)
TOOLS REQUIRED:
Standard Socket Set
Open-end Wrench Set
Ratcheting Wrench
HARDWARE:
QTY DESCRIPTION PART #
1 5/16-18 x 1” Hex head bolt GSM33012
2 5/16” Flat washers GSM31006
1 5/16-18 Nylock Nut GSM30017
SUB ASSEMBLY:
1. Identify hardware and components.
2. Remove inner and outer seat base bolts on passenger side front seat.
INSTALLATION:
1. POSITION C-TCB-31:
• Lean seat back and slide C-TCB-31 Base between floor of vehicle and seat base on
inner bolt.
• Screw in factory seat base inner bolt and hand tighten at this time.
• Slide cross brace under passenger seat base outer bolt.
• Screw in factory seat base outer bolt and hand tighten at this time.
• Bolt cross brace to tab on square tube of Base using 5/16-18 x 1” Hex head bolt,
washers and Nylock nut.
• Tighten all bolts at this time.
Note: It is recommended to mount C-TCB-31 base as far under seat base as possible.
Cross Brace
Inner Pole
Base