Quick Start Guide
16
Wall Mounting
1. Attach the unit side of the wall mounting bracket to the back of the unit with three M5 x .8mm x 10mm long
stainless steel screws. (Fig. 1) Note that a single bolt attaches in the middle at the top of the bracket and two
bolts attach the bottom of the bracket. Holes on the top left and right corner are unused.
2. Attach the wall piece of the wall mounting bracket to the wall surface so that it is oriented as shown, with
the side rails away from the wall and locking fl anges on the bottom (Fig. 2).
3. Attach the grounding cable to the grounding connection on the VeeaHub heat sink, as described on
Pages 8-9.
4. Hang the unit assembly on the wall piece of the bracket by matching up the bracket side fl anges and sliding
the unit assembly down onto the mounted wall piece until it rests on the locking fl anges. Insert two M8 screws
into the locking fl anges at the bottom to fasten the two pieces of the mounting bracket together (Fig. 3).
In the case of the wall mount bracket, there are two pieces: one piece attaches to the
VHH09 (LoRa) unit and the other piece gets mounted to the surface of the wall.