User Manual

www.hawkeyeelectronics.com
Mounting Location “DONT’s”
NOTICE:
To deliver consistent, accurate
readings, the transducer must have
a continuous supply of non-
turbulent water. Do not mount the transducer
in an area of turbulence or bubbles.
Never install the transducer where the boat may be
supported during trailering, launching, hauling, or
storage.
NEVER MOUNT:
A. Behind water intakes, discharge openings, or
thru-hull fittings.
B. Behind strakes, struts, or hull irregularities.
C. Behind transom steps or pockets.
D. Behind eroding paint, hull deformities, or
marine growth.
E. Behind rivets or strakes on aluminum boats.
F. Behind the step on stepped hulls.
G. Directly on the “V” in the hull.
H. Behind propellers or anywhere propeller
turbulence will interrupt the flow of “clean”
water to the transducer.
I. In areas where the hull has a reverse angle.