User Manual

- 4 -

INITIAL SETUP

MPORTANT

If you are going to be using the Fish Finder in Temperatures Below

20º F (-7 ºC) you must use Lit

hium ‘AAA’ Batteries. Cold

temperatures significantly reduce the power output of Alkaline

batteries, which will inhibit the performance of the Fish Finder.

IMPORTANT:

To ensure your FishTrax™ 1C remains water tight, coat the battery

cover seal with petroleum jelly (Vaseline®)

or silicon grease

(available at any dive shop) each time you replace the batteries.

WARNING:

Never mix different brands of batteries. Never mix new and used

batteries (alkaline, lithium, argon zinc, & rechargeable). Never use

damaged batteries. REMOVE BATTERIES DURING STORAGE.

REMOVE DEAD BATTERIES IMMEDIATELY.

Installing the Batteries:

1. Using a flat head screw driver, turn the screws on the

battery cover counter clockwise to loosen.

2. Lift the battery door off the display housing.

3. Install 4 “AAA” batteries. Be certain to align the

batteries as per the diagram within the battery

compartment.

4. Reinstall the battery cover completely by reversing

these steps.

Connecting the Sonar Sensor Cable:

1. Align the pins on the sonar sensor cable plug with the plug on the

display.

2. Firmlly press the two plugs together until the red o-ring on the

display connector is squashed between the plugs.

3. Tighten the locking nut on the display plug until it is snug by

turning it clockwise. Finger tighten only, do not use tools.