User Manual

18
To connect, select a SSID or an AP that you wish to connect to and click Connect
and OK. (Note: if the selected SSID has encryption, you need to enter a security
key in order to connect (refer to Chapter 7 for network settings). If the selected SSID
is an open network or has no encryption, “none” will be listed under Encryption
column.)
When you are successfully connected, a handshake icon
will appear on the left,
next to the selected AP.
When the HWDN1 fails to connect, the status bar (bottom left of the HWDN1
Wireless Utility) will show “Disconnected”.
7.1. NETWORK SECURITY (WEP, WPA…)
If your AP/Router has a networking security key, you must enter the same security
key and setting. If you do not have the Network Encryption key, please request it
from the Network Administrator or the person who set up your wireless network.
After you obtained the network security information, open up Hawking Wireless
Utility. Continue below to set up your Network Security Code.
7.1.1. WEP Setup
If the SSID or Access
Point you wish to connect
has WEP authentication,
select the SSID and click
on Connect.