User Manual

Model No: HWRG1

If required, connect any port to a normal port on another Hub, using a standard LAN cable.

Any LAN port on the Wireless Router will automatically function as an "Uplink" port

when required.

3. Connect WAN Cable

Connect the DSL or Cable modem to the WAN port on the Wireless Router. Use the cable

supplied with your DSL/Cable modem. If no cable was supplied, use a standard cable.

4. Power Up

• Power on the Cable or DSL modem.

• Connect the supplied power adapter to the Wireless Router and power up.

Use only the power adapter provided. Using a different one may cause hardware damage

5. Check the LEDs

• The Power LED should be ON.

• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.

• For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is

also ON.)

• The WAN LED should be ON.

• The WLAN LED should be ON

For more information, refer to Front-mounted LEDs in Chapter 1.