User Manual

Source Address/Mask: Enter desired source IP address and netmask. i.e. 192.168.2.10/32.
Source Port: Enter a port or a range of ports as start:end. i.e. port 20:80
Destination Address/Mask: Enter desired destination IP address and netmask. i.e. 192.168.1.10/32
Destination Port: Enter a port or a range of ports as start:end. i.e. port 20:80
In/Out: Applies to Ingress or egress packets.
Protocol: Supports TCP, UDP or ICMP.
Listen: Click Yes radial button to match TCP packets only with the SYN flag.
Policy: Deny to drop and Pass to allow per filter rules
Interface: The interface that a filter rule applies
Schedule: Can choose to use rule by “Time Policy”
All packets are allowed by default. Deny rules could be added to the filter list to filter out unwanted packets and
leave remaining allowed.
Total of 20 rules maximum allowed in the IP Filter List. All rules can be edited or removed from the List. When you
create rules in the IP Filter List, the prior rules maintain higher priority. To allow limited access from a subnet to a
destination network manager needs to create allow rules first and followed by deny rules.