User Manual

OSPF Service: By default, it is disabled.
Router ID: The router ID is typically derived by each router from its interface IP address.
Distribute RIP over OSPF: Allow RIP routes will redistributed into OSPF.
RIP Settings
RIP Service: By default, it is disabled.
Side: Specify desired interface WAN, LAN for sending and receiving of RIP packets.
Distribute OSPF over RIP: Allow OSPF routes redistributed into RIP.
Static Routing Setup
Service: Click Enable to activate static routing.
Destination Net/Mask: Specify desired destination IP network address with format of A.B.C.D/M
Via: Select a next hop of Gateway or Interface to the destination IP network.
Gateway: Enter gateway IP address
Interface: Choose the interface via LAN or WAN
Protocol: Set static routing rule to RIP or OSPF network. Select RIP to associate specific
network on RIP routing process. Select OSPF to associate specific network with
the specified area on OSPF routing process