User Manual

Key Index: You can set up to four sets of WEP key, and you can decide which key is being used by
default here. If you don’t know which one you should use, select ‘Key 1’.
WEP Key 1-4: You can chose either HEX or ASCII for your WEP key value, for 64bit encryption strength
can use 10 digits for HEX (0~9, a~f and A-F) or 5 digits for ASCII (0~9, a~z and A~Z), for
128bit encryption strength can use 26 digits for HEX (0~9, a~f and A-F) or 13 digits for
ASCII (0~9, a~z and A~Z), for 152bit encryption strength can use 32 digits for HEX (0~9,
a~f and A-F) or 16 digits for ASCII (0~9, a~z and A~Z)
3-5-8-3 Wi-Fi Protected Access (WPA-PSK or WPA2-PSK):
When you select this mode, the wireless access point will use WPA encryption, and the following setup menu will
be shown on your web browser:
Cipher Suite: AES is short for Advanced Encryption Standard, The AES cipher is specified as a number
of repetitions of transformation rounds that convert the input plain text into the final
output of ciphertext. Each round consists of several processing steps, including one that
depends on the encryption key. A set of reverse rounds are applied to transform
ciphertext back into the original plaintext using the same encryption key. TKIP is short
for Temporal Key Integrity Protocol, TKIP scrambles the keys using a hashing algorithm
and, by adding an integrity-checking feature, ensures that the keys haven’t been
tampered with.
Key Type Select the type of pre-shared key, you can select ASCII (8 or more alphanumerical
characters, up to 63), or Hex (64 characters of 0-9, and a-f).
Pre-shared Enter the information for pre-shared key; the format of the information shall according
to the key type selected. Pre-shared key can be either entered as a 256-bit secret in 64
HEX digits format, or 8 to 63 ASCII characters
Hawking recommends using WPA2-PSK w/ AES cipher suite as your default level of security.
Click Finish and the device will automatically restart and save your settings. After you have finished, this device
will act as a Wireless Internet Service Provider. The device just needs to be powered on via the P-Data Out port on
the PoE adapter and can be standalone (you can also connect any wired clients to the 10/100 Data In Port or
LAN2). Please change your computer IP address back to “Obtain an IP automatically”.