User Manual

4-3 LAN Setup
Click under system, LAN Setup
4-3-1 LAN IP Setup
The administrator can set it to obtain (Dynamic IP) an IP automatically or manually setup (Static IP) the LAN IP
address of the device.
If you select Dynamic IP, you can input your host name (if required)
If you Static IP, you can enter in your settings here:
IP Address: The IP address of the LAN port; default IP address is 192.168.2.254
IP Netmask: The Subnet mask of the LAN port; default Netmask is 255.255.255.0
4-3-2 DHCP Setup
Devices connected to the system can obtain an IP address automatically when this service is enabled. (This feature
is only available in Router AP, ClientBridge + Repeater AP and CPE + Repeater AP Modes)