Manualshelf

Owners manual

ManualsBrandsHawking Technology ManualsComputers & LaptopsHigh Power Outdoor Wi-Fi Access Point, Bridge with built-in AP Controller and PoE included (HPOW5CM)
31323334353637383940
39
When WISP Mode is chosen, the system can be configured in Wireless Internet repeater mode. In this
mode, the device can wirelessly connect to a WISP (wireless internet service provider), ie. Another
wireless AP, HotSpot, etc. It can then wirelessly repeat the signal and can even act as a router for these
signals. NAT is enabled and wired and wireless computers can share the same IP range. This section
provides a detailed explanation for users on how to configure this mode.
Choose WISP Mode
Log into the settings page, go to system and select “Mode Setup”
Choose WISP Mode and click save & reboot.
Now, open your browser and go to 192.168.2.254. It should take you back into the settings page. Go to
“Wizard”. Click “Next”