Specification Sheet

09/20 1200 Series Config 1000 Bubbler Deactivation Page 1 of 2
1455 Kleppe Lane Sparks, NV 89431-6467 [phone] Fax [phone]
E-mail: [e-mail]  website: www.hawsco.com
No. 0080030539 (1)
REQUIRED TOOLS (OR EQUIVALENT):
□ 1/4” Bit-holding screwdriver
□ #2 Phillips bit
□ 5/16” Nut Driver (Not required but helpful)
□ T20 Torx bit (included)
□ Plastic mechanical pencil or other similar nonmetallic pointed and slender object.
REQUIRED PARTS
□ Cover plate with attached 3/8” stem (both included)
□ Rubber gasket (included)
□ QTY 3 #8x1/4 Phillips Head Screws (included)
PROCEDURE
GENERAL NOTES:
a. Deactivation of the bubbler is intended to be for temporary durations of less than
one year.
b. Parts removed from the cooler should be kept in the supplied packaging and
stored in a proper location so that they can be used to restore the cooler to full
functionality at a later time.
BUBBLER DEACTIVATION AND INSTALLATION OF
COVER PLATE
CONFIGURATION 1000 FOR MODELS 1211S, 1211SF, 1212S, & 1212SF
1201SFH, 1202SFH, 1211SH, 1211SFH, 1212SH, 1212SFH
INSTALLATION, OPERATION
&
MAINTENANCE INSTRUCTIONS
SAFETY PRECAUTIONS
CAUTION: SEE NOTES ON 1200 SERIES O&M, DOC NUMBER 0510000866
CAUTION: WEAR GLOVES WHEN WORKING NEAR EDGES OF SHEET METAL
PARTS.
NOTE TO INSTALLER: Please leave this information with the Maintenance Department.
SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL PLEASE CALL:
TECHNICAL SUPPORT: 1-800-766-5612
FOR CUSTOMER SERVICE: 1-888-640-4297