Specification Sheet

MODEL 6429

REPLACEMENT FILTER

SPECIFICATIONS

PERFORMANCE DATA SHEET

APPLICATIONS

This filter cartridge is designed specifically for the Brita® Hydration

Station™.

IMPORTANT NOTICE: Read this Performance Data Sheet and compare

the capabilities of this unit with your actual water treatment needs. It is

recommended that, before purchasing a water treatment unit, you have your

water supply tested to determine your actual water treatment needs.

This system has been tested according to NSF/ANSI 42/53 for the reduction of the substances listed. The concentration of the indicated

substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the

system, as specified in NSF/ANSI 42/53.

Testing was performed under standard laboratory conditions. The contaminants or other substances removed or reduced by this water

treatment device are not necessarily in all users’ water. Filter performance may vary based on local water conditions.

Model 6429 Brita® Hydration Station™ replacement filter cartridge is used on

models 2000S and 2000SMS systems which are tested and certified by CSA

against NSF/ANSI Standard 42 for the reduction of chlorine (taste and odor)

and against NSF/ANSI Standard 53 for the reduction of lead and 99.99% of

cysts. It is a carbon block filter cartridge with a service life of 1 year/2,500 gallon

(9463 L). Filter contains an onboard chip to store total gallon usage; this chip

interfaces with an electronic life cycle control system to allow water flow only

until the filter reaches its total gallon capacity.

Manufactured by Haws Corporation® • www.britahydrationstation.com • Call Haws at 1.888.909.4297

Substance Influent Challenge Reduction Maximum Permissible Average Percent

Concentration Requirement Product Water Concentration Reduction

Chlorine, 2.0 mg/L ± 10% ≥ 50% N/A 96.6%

Taste

and Odor

Lead 0.15 mg/L ± 10% N/A 0.010 mg/L 99%

Cyst Minimum 50,000/L 99.95% N/A 99.99%

Brita

Hydration Station

with Lifecycle Control

PAGE 1
Brita Hydration Station ® TM with Lifecycle Control MODEL R E P L A C E M E N T F I LT E R 6429 SPECI F I CAT IO N S Model 6429 Brita® Hydration Station™ replacement filter cartridge is used on models 2000S and 2000SMS systems which are tested and certified by CSA against NSF/ANSI Standard 42 for the reduction of chlorine (taste and odor) and against NSF/ANSI Standard 53 for the reduction of lead and 99.99% of cysts.
PAGE 2
FILTE R LOCATIO N & R EP L AC EM E NT An instructional label is visible when the hinged panel is opened, noting how to replace the filter (see below). NOTE: Water does not need to be shut off to replace the filter cartridge; however, it should be shut off if the filter head is going to be left without a cartridge installed for a long period of time. 1. Disconnect old filter cartridge’s wiring and unscrew cartridge. 2. Screw new cartridge firmly into filter head; connect cartridge wiring. 3.