User Manual

APPROVED: DRAWN:
PART NUMBER
SCALE:
SHEET OF
REVISION
DRAWING TYPE: SIZE: A
BY:ECN NO.
PAGE
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved.
HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
C
R
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
[phone] FAX [phone]
E-MAIL: [e-mail]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
MJ
06/30/16
15
0002080045.D
PORTABLE EYEWASH
7501/7501T/7501TH/7501T240/7501T240H
1:1
12
FV
09/21/16
5086
VWC
7 of 8
INSTALLATION
5139
2016
CC
ACTIVE
* 21-1/2"
[546mm]
33" TO 53"
[838mm TO 1346mm]
TO FINISHED FLOOR
* 22"
[559mm]
* 22"
[559mm]
* 8"
[203mm]
* 16-3/4"
[425mm]
* 10-1/8"
[257mm]
3X
ø 5/16"
ø [8mm]
MOUNTING
BRACKET
(SUPPLIED)
54-1/2" TO 66-1/2"
[1384mm TO 1689mm]
"ON"
POSITIONPOSITION
STAND BY
"OFF"
3X 1/4" MOUNTING
HARDWARE
(NOT SUPPLIED)
* 14-1/2"
[368mm]
TO FINISHED FLOOR
1 1/8"
[29mm]
2 1/4"
[57mm]
1 1/4"
[32mm]
DO NOT EXCEED WATER FILL LINE.REFER TO INSTALLATION INSTRUCTIONS IN "OPERATION AND MAINTENANCE MANUAL" FOR PROPER FILLING PROCEDURES.
NOTES: 1. TO COMPLY WITH ANSI Z358.1-2014 FOR EMERGENCY EYEWASH OR EYE/FACE WASH AND SHOWER EQUIPMENT: - UNIT SHALL BE INSTALLED IN ACCORDANCE WITH MANUFACTURER'S INSTRUCTIONS AND ACCEPTABLE PLUMBING PRACTICES. - EYEWASH OR EYE/FACE WASH SHALL BE POSITIONED WITH NOZZLES NOT LESS THEN 83.8 CM (33 IN.) AND NO GREATER THAN 134.6 CM (53 IN.) FROM SURFACE ON WHICH USER STANDS AND 15.3 CM (6 IN.) MINIMUM FROM WALL OR NEAREST OBSTRUCTION. 2. UNIT MUST BE LEVEL FROM FRONT TO BACK AND SIDE TO SIDE. ALL THREE MOUNTING HOLES ON MOUNTING-BRACKET MUST BE USED TO PROPERLY SECURE EYEWASH UNIT TO WALL. (NOTES CONTINUED ON SHEET 2 OF 2)
3
3
3
MODEL 7501 (SHOWN) MODELS 7501T/7501TH/7501T240/7501T240H - WITH
(SEE SHEET 2 OF 2)
FLOOR
LINE
HEATED BLANKET