Installation Instructions

SUPPLIED WITH 4
COMMON FAUCET
ADAPTERS TO ALLOW
UNIT TO WORK WITH
ALMOST ANY FAUCET
STANDARD INTERFACE
WITH LOCKNUT
(will fit most faucets)
SUPPLIED WITH
PRE-ASSEMBLED .5 GPM
MULTI-STREAM PCA SPRAY
AND OPTIONAL 1 GPM
SINGLE STREAM PERLATOR
HAWS CORPORATION
1455 KLEPPE LANE, SPARKS, NV 89431
775.359.4712 +1.888.640.4297
www.axioneyepod.com
MODEL 7620
COIN NOTCHES USED
TO INSTALL STANDARD
INTERFACE TO FAUCET
EASY INSTALLATION
1. REMOVE AERATOR FROM YOUR FAUCET.
2. CHOOSE AND INSTALL THE APPROPRIATE ADAPTER BY THREADING IT ON TO
YOUR FAUCET, IF NECESSARY. (THE STANDARD INTERFACE ON THE eyePOD
TM
WILL FIT MOST FAUCETS).
3. REMOVE LOCKNUT AND STANDARD INTERFACE AND INSTALL THEM ON TO
YOUR FAUCET TOGETHER USING COIN SLOTS. A QUARTER WORKS WELL.
4. THREAD THE LOCKNUT BACK ONTO THE eyePOD
TM
MAKING SURE THAT THE
eyePOD
TM
IS POSITIONED FACING FORWARD (As shown in Faucet Mode).
NOTE: FAILURE TO INSTALL PROPERLY MAY AFFECT ITS PROPER FUNCTIONING.
INSTALLATION AND USE NOTES
1. THE eyePOD
TM
IS DESIGNED FOR AND SHOULD ONLY BE USED WITH WATER
BETWEEN 60
o
F (15
o
C) AND 100
o
F (37
o
C). IF ABOVE 100
o
F (37
o
C) THE
EYEWASH STREAMS WILL BE SHUT OFF BY INTERNAL THERMO-STATIC VALVE.
NOTE: USE OF THE PRODUCT WITH WATER OUTSIDE THE STATED TEMPERATURE
RANGE MAY AFFECT ITS OPERATION AND RESULT IN A RISK OF SERIOUS BURNS
OR REDUCE ITS EFFICIENCY.
2. THE eyePOD
TM
IS SELF DRAINING WHEN PLACED IN THE FAUCET MODE. IT
SHOULD ALWAYS BE RETURNED TO THE FAUCET MODE AFTER EYEWASH USE
TO ALLOW FOR DRAINAGE.
NOTE: WHEN INSTALLING THIS UNIT, LOCAL, STATE, OR FEDERAL CODES
SHOULD BE ADHERED TO.
NOTE: ANSI Z358.1 COMPLIANT WHEN PROPERLY INSTALLED IN A WATER
SYSTEM PROVIDING PROPER PRESSURE, VOLUME AND TEMPERATURE.
THE eyePOD
TM
IS
SWITCHED BETWEEN
MODES OF OPERATION
BY ROTATING THE HEAD
IN EITHER DIRECTION.
WATER IS STILL ACTUATED
USING YOUR FAUCET
CONTROLS.
ROTATE IN EITHER DIRECTION
EYEWASH MODEMODE SELECTION FAUCET MODE
EASY TO USE TURN ON FAUCET AND SELECT MODE OF OPERATION