User Manual

2/16 Model 8300.158 Page 3 of 5
STEP 7: Assemble the sign onto the unit. Use the strap, screws, washers and nuts
provided to mount the sign onto the upright. The sign should be positioned for
maximum visibility.
STEP 8: Air Gap Assembly: The 7” hose is connected to the SP158B valve, the 8” hose is
connected to the 3 way valve, and tube at bottom (8”) is connected to barb fitting
on elbow at the bottom of shower.
STEP 9: Before connecting the supply water line to the emergency shower, FLUSH THE
LINE THOROUGHLY.
TROUBLESHOOTING
PROBLEM REPAIR CHECKLIST
1. No flow. 1. Check the main shut-off valve.
2. Insufficient water flow 2. Verify minimum 30 psi (2 ATM) flowing
supply line pressure.
3. Insufficient water flow on eye/face
wash, however, shower is sufficient.
3 Probable clogging of flow control due to
inadequate line flushing. Unscrew
eye/face wash head and adapter.
Disassemble adapter to gain access and
clean rubber flow control.
4. Eye/face wash streams do not meet
at desired eye level.
4. Possible blocked flow control, see above
solution. Possible non-leveled eye/face
wash assembly.
5. Insufficient water flow at the
showerhead, however, eye/face wash
is sufficient.
5. Probable clogging of flow control inside
showerhead. Unscrew showerhead off
of elbow and clean rubber flow control.
6. Water does not drain properly 6. Check your drain system for debris.
Check the main waste line of your
building to see if it does handle the
capacity required for the entire drainage
system.
7. Water leaks between joints or fittings 7. Tighten loose connections. If leak
persists, the application of hot water will
sometimes reseat improperly applied
joint compound. After 30 minutes wait
and retest. A persistent leak will
necessitate reassembly and additional
sealant.
8. Water flows from 3-way bleed valve
when in closed position.
8. Remove nut and flag. Rotate stem 180
◦
and reassemble flag and nut.
9. Continuous water flow from SP158B
when in closed position.
9. Replace thermostat sub assembly.
For more information about Haws products, see our website: www.hawsco.com
© 2016 Haws® Corporation – All Rights Reserved
HAWS® and other trademarks used in these materials are the exclusive property of Haws
Corporation.