User Manual

ManualsBrandsHaws ManualsSafety8317CTFPC1D1

01/14 Model 8317CTFPC1D1 Page 1 of 10

No. 0002077032

(

)

1455 Kleppe Lane Sparks, NV 89431-6467 (775) 359-4712 Fax (775) 359-7424

E-mail: haws@hawsco.com website: www.hawsco.com

Model 8317CTFPC1D1

INSTALLATION, OPERATION

MAINTENANCE INSTRUCTIONS

LIMITED WARRANTY

HAWS warrants that this specific product is guaranteed against defective material or poor

workmanship for a period of one year from date of shipment. HAWS liability under this

warranty shall be discharged by furnishing without charge F.O.B. HAWS Factory any goods,

or part thereof, which shall appear to the Company upon inspection to be of defective mate-

rial or not of first class workmanship, provided that claim is made in writing to Haws within a

reasonable period after receipt of the product. Where claims for defects are made, the de-

fective part or parts shall be delivered to the Company, prepaid, for inspection. HAWS will

not be liable for the cost of repairs, alterations or replacements, or for any expense connect-

ed therewith made by the owner or his agents, except upon written authority from HAWS,

Sparks, Nevada. HAWS will not be liable for any damages caused by defective materials or

poor workmanship, except for replacements, as provided above. Buyer agrees that Haws

has made no other warranties either expressed or implied in addition to those above stated,

except that of title with respect to any of the products or equipment sold hereunder and that

HAWS shall not be liable for general, special, or consequential damages claimed to arise

under the contract of sale.

The emergency equipment manufactured by HAWS is warranted to function if installation

and maintenance instructions provided are adhered to. The units also must be used for the

purpose for which they were intended. This product is intended to supplement first-aid

treatment. Due to widely varying conditions, Haws cannot guarantee that the use of this

emergency equipment will prevent serious injury or the aggravation of existing or prior inju-

ries.

NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED, PROVIDED

OR GIVEN BY HAWS.

NOTE TO INSTALLER: Please leave this information with the Maintenance Department.

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS

MODEL PLEASE CALL:

TECHNICAL SUPPORT: 1-800-766-5612

FOR CUSTOMER SERVICE: 1-888-640-4297

Summary of content (10 pages)

PAGE 1
INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS 1455 Kleppe Lane Sparks, NV 89431-6467 (775) 359-4712 Fax (775) 359-7424 E-mail: haws@hawsco.com website: www.hawsco.com No. 0002077032 (9) Model 8317CTFPC1D1 NOTE TO INSTALLER: Please leave this information with the Maintenance Department. LIMITED WARRANTY HAWS warrants that this specific product is guaranteed against defective material or poor workmanship for a period of one year from date of shipment.
PAGE 2
RECOMMENDED TOOLS: Pipe joint sealant, screwdriver, pipe wrench, three (3) rust resistant anchors (3/8” diameter), silicone caulking, level. MOVING UNIT: Side arms on unit for power connection and heat trace termination are specified as “NO LIFT” on installation drawing. These are not designed to support the weight of the unit and attempts to move the unit using them will cause damage that will void the unit’s warranty.
PAGE 3
INSTALLATION PROCEDURE STEP 3: Connect electrical power supply conduit to input junction box using suitable conduit fitting into 3/4” NPT inlet. Install optional area light and indicator light, if desired. For MODEL 8317CTFP C1 D1 (120V): connect 120 volt AC line to 16 gauge shower wires as follows: Black = 120 VAC, Red = 2nd Hot, Green = Ground. (Turn on power supply to complete installation. See Electrical Schematic Drawing, Sheet 4 of Installation Drawing).
PAGE 4
TROUBLESHOOTING PROBLEM REPAIR CHECKLIST 1. Continuous flow from freeze bleed valve. 1. If bleed water temperature is above 45ºF (7ºC), service bleed valve. For specific instruction regarding removal, maintenance and re-installment of this model, contact Haws Technical Support at 1-800640-5612. If below 45ºF (7ºC), verify electric power to unit, then check thermostat. See item 3 below. Once opened, cold supply water, (45ºF (7ºC), will keep freeze bleed valve open.
PAGE 5
TROUBLESHOOTING (Continued) PROBLEM REPAIR CHECKLIST 8. Shower and eye/face wash valve stem leak. 8. Remove shower arm or eye/face wash push flag. Peel black trim strip from shower and separate housing halves. Peel back or remove insulation to gain access to valve. Remove “U” bracket from valve stem and tighten valve stem hex packing nut to stop leak. Reassemble bracket, insulation, shower housing and valve arm. 9. Shower and eye/face wash valve leaks. (Does not shut off completely). 9.
PAGE 6
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE. SHOWER VALVE ASSEMBLY 1-1/4" UNION SP829 SHOWER HEAD SP178 SHOWER/EYEWASH SIGN SP200 PULL ROD EYEWASH VALVE ASSEMBLY SP170 TEST TAG SP158B FREEZE PROTECTION VALVE (SEE PAGES 8 & 9 FOR ADDITIONAL COMPONENTS) 1455 KLEPPE LANE SPARKS, NEVADA 89431 (775) 359-4712 FAX (755) 359-7424 E-MAIL: HAWS@HAWSCO.COM WEBSITE: WWW.HAWSCO.
PAGE 7
6 3/4 [171] POWER CONNECTION 1-1/4" IPS SUPPLY UNION (INLET) TOP SUPPLY SHOWN. SEE STEP 2 OF INSTALLATION PROCEDURE IN THE O&M MANUAL TO CONVERT TO A BOTTOM SUPPLY UNIT THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE. VIEW ROTATED 180° NOTE: PULL ROD AND HANDLE NOT ASSEMBLED. ORIENTATION OF HANDLE MUST BE IN UP POSITION WHEN FULLY CLOSED AND PULL ROD INSERTED IN HOLE SHOWN.
PAGE 8
(NOTES CONTINUED ON SHEET 3 OF 4) RUBBER GROMMET B FEMALE SECTION OF UNION (PART OF SHOWER UNIT) MALE SECTION OF UNION A (PART OF VALVE SUB-ASSY) CABLE-TIE, 15" / PN 0005972499 A B CABLE-TIE, 15" / PN 0005972499 C NA D SIZE: A 9 REV 4 15363A SHEET 2 OF DRAWING NO. 0002077032 PART NUMBER 1455 KLEPPE LANE SPARKS, NEVADA 89431 (775) 359-4712 FAX (755) 359-7424 E-MAIL: HAWS@HAWSCO.COM WEBSITE: WWW.HAWSCO.
PAGE 9
JACKET/TUBE INTERSECTION TRIM SEAL E SLICED TUBE SECTION (TOP SIDE) E STRAP, 2-PC CABLE-TIE, 20" L D HEAD, 2-PC CABLE-TIE / PN 0002850165 D OUTER TUBE D SCALE: NA MODEL(S) INNER TUBE INSULATION SEAM D PERPENDICULAR D ADHESIVE SEAM E BARBED CONNECTOR D SLICED TUBE SECTION (BOTTOM SIDE) ECN NO. REVISED PER BY: 4632 HM ECN: 4888 DRAWN: DATE: CHK'D.: VWC 12/2/12 APPROVED: DATE: SIZE: A 9 REV 4 15363A SHEET 3 OF DRAWING NO.
PAGE 10
BLACK WHITE GREEN GREEN GROUND TERM. RING (3X) GREEN/YELLOW COM NO NC TERM. RING RED (30") THERMOSTAT 1:1 SIZE: A SHEET 4 OF REV 4 15363A00 9 DRAWING NO. 0002077032.D PART NUMBER 1455 KLEPPE LANE SPARKS, NEVADA 89431 (775) 359-4712 FAX (755) 359-7424 E-MAIL: HAWS@HAWSCO.COM WEBSITE: WWW.HAWSCO.COM INSTALLATION 8317CTFPC1D1 DRAWING TYPE: TERMINAL BLOCK SCALE: MODEL(S) HEAT TRACE CABLE ECN NO. REVISED PER BY: 4140 ECN: 4888 HM DRAWN: DATE: CHK'D.