Installation Guide

375mm
14 3/4"
8 1/2"
216mm
1/2" IPS
SUPPLY
241mm
WALL
9 1/2"
38mm
1 1/2"
838mm TO 1397mm
33" TO 45"
FLOOR LINE
273mm
10 3/4"
51mm
2"
4X
102mm
4"
*4X
9/32"
NOTES:
1. DIMENSIONS MAY VARY ±1/2" (12.7mm).
2. IN ORDER TO COMPLY WITH STATE CODES, THE USE OF A VACUUM BREAKER
IS REQUIRED WITH ALL HAND HELD EYE/FACE WASH AND BODY SPRAY UNITS
(HAWS OFFERS MODEL SP212).
3. TO COMPLY WITH ANSI Z358.1-2009 FOR EMERGENCY EYEWASH OR EYE/FACE
WASH EQUIPMENT:
- UNIT SHALL BE INSTALLED IN ACCORDANCE WITH MANUFACTURER'S
INSTRUCTIONS AND ACCEPTABLE PLUMBING PRACTICES.
- EYEWASH OR EYE/FACE WASH SHALL BE POSITIONED WITH NOZZLES NOT
LESS THEN 83.8 CM (33 IN.) AND NO GREATER THAN 114.3 CM (45 IN.) FROM
SURFACE ON WHICH USER STANDS AND 15.3 CM (6 IN.) MINIMUM FROM WALL
OR NEAREST OBSTRUCTION.
4. MOUNTING HARDWARE SUPPLIED BY OTHERS.
*
APPROVED:
DRAWN:
PART NUMBER
DRAWING NO.
SCALE:
SHEET OF
REV
DRAWING TYPE: SIZE: A
BY:ECN NO.
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved.
HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
C
R
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
[phone] FAX [phone]
E-MAIL: [e-mail]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
CH 08/95
12086A00 11
0002080210.D
8905
WALL MTD EYE/FACE WASH
1:4
11
FV 01/08/15
VWC
INSTALLATION
4938
2014
5
5 ASSEMBLE EYE/FACE WAS ASSEMBLY TO HOSE; ORIENT TAB
ON ASSEMBLY AWAY FROM USER.