Envoy Owners Handbook

1.20

Turn the mower on its side.

Firmly grip the end of the cutterblade (2) with a gloved hand and

remove bolt (1). When replacing ensure that the new cutterblade is the

correct way up with the turned edges facing towards the motor before

locating onto the two carrier pins. Secure the cutterblade fixing nylon

bolt and tighten to the specified torque of 20Nm.

The cutterblade has sharp edges. ALWAYS wear strong gloves to

protect your hands when working on the cutterblade. DO NOT

rotate tools towards the cutting edges to avoid the risk of injury

should the tool slip. ALWAYS use genuine Hayter replacement

parts.

The condition of the cutterblade and its mounting arrangement should

be checked regularly for signs of wear or damage. Ensure that the cut-

terblade is not bent or cracked.

A damaged cutterblade that is out of balance will vibrate excessively

and may break. DO NOT use an unbalanced cutterblade.

Regularly check that the bolt securing the cutterblade is tightened

to the specified torque of 20Nm.

Replace the cutterblade every 2 years or sooner if excessively worn or

damaged.

To prevent injury it is wise to seek assistance when turning the mower

on its side.

Cutterblade Removal

MOWER

MAINTENANCE

100053 (1) 27/4/04 11:24 am Page 1.20