User's Manual

Compatibility
This product is compatible with all Aqua Logic PS controls operating with software
revision r2.00 or higher and using an AQL2-BASE-RF base station operating with
software revision r3.00 or higher. Note that this product will NOT communicate with
the AQL-BASE-RF base station. To verify the software level of your Aqua Logic
control, press the Menu button (possibly multiple times) until "Diagnostic Menu" is
displayed. Press the ">" or "<" keys (possibly multiple times) until the main software
revision level is displayed (the revision should be 2.00 or higher). Next, press the ">"
key (possibly multiple times) until the "RF Base" revision level is shown (the revision
should be 3.00 or higher).
If the software revision level is less than those specified above, contact the Goldline
Technical Service Dept. from Monday through Friday, 8AM to 8PM Eastern at 888-
921-7665 for information on upgrades.
Installation
Installation - AQL2-Wx-RF-PS-x Wall Mount models
1. Base Receiver required: For operation of the AQL2-Wx-RF-PS-x, the Aqua
Logic control unit must have an AQL2-BASE-RF base receiver installed. Note
that this unit will NOT operate with the AQL-BASE-RF base receiver.
2. Select Location: There are several considerations in choosing the location for
the wireless remote display/keypad:
Protected from the weather: The wireless remote display/keypad must be
mounted indoors or in a weather protected area (rain should never hit the
wireless remote display/keypad). The wireless remote display/keypad is
designed to mount onto a standard electrical utility box (same size as used
for a triple light switch) or can be mounted directly onto any wall surface.
Within range of Base Receiver: The wireless remote display/keypad must
be installed within 200 ft. (assuming the signal will have to travel through
walls) or 400 ft. (line of sight) from the Base Receiver which is typically
mounted on the Aqua Logic main control unit at the pool equipment pad.
The Base Receiver can also be mounted up to 500 ft. away from the main
control unit to shorten the distance between it and any wireless remote. See
the "Remote Mounting of the Base Receiver" section of the Base Receiver
manual for more details.
Near 120V wall outlet: The wireless remote display/keypad uses a plug-in
power supply with a 6 ft. cable.
3. Mount on wall: The wireless remote display/keypad must be mounted indoors
or in a weather protected area (rain should never hit the display/keypad). Refer
to the diagram on the following page.
a. Remove display/keypad baseplate from the cover by inserting a screwdriver
in the slot shown below. Lift up on the cover while pushing gently with the
screwdriver. See Fig. 1.
b. Thread the wall mount power supply’s output connector from behind and
through the opening in the left side of the baseplate. See Fig. 2.
1
10