User's Manual

5. Menu

This location on the Aqua Pod's display is used for the direct communication to the

Aqua Logic control system. Access to the Aqua Logic menus and submenus are

displayed here. This information "mimics" the Aqua Logic's local display, as well as

any other remote control connected to the system. Any programming changes made

from the Aqua Pod, Aqua Logic or any remote in the system will be displayed here.

When no changes have been made from any location for more than 2 minutes, the

Aqua Pod will scroll through each display of the Aqua Logic's default menu. Refer to

the Aqua Logic Installation and Operation manuals for more information.

6. Softkeys

The Aqua Pod allows for easy On/Off/Auto control of your pool equipment, regard-

less of how they have been previously programmed. Using the Aqua Pod's softkey

pushbuttons, any of your pool's equipment shown in this location of the display can

be turned On/Off or returned to automatic operation.

Aqua Pod Pushbuttons

Refer to the diagram and corresponding information below.

1. SoftKey Pushbuttons

Three softkey pushbuttons are provided to allow the user to conveniently turn on or

off pool equipment that has been previously designated in the Map Softkeys menu.

Refer to Mapping Softkeys section on page 6 for information on how to assign

specific pool equipment to each softkey.

2. Aqua Logic Programming Pushbuttons

These keys are used for programming and communicating with the Aqua Logic. They

operate in the same manner as the Aqua Logic's local keypad buttons. Refer to the

Aqua Logic Installation and Operation manual for detailed information on the use of

these buttons.

3. System Off

Pressing this button will turn all Aqua Logic outputs off. They will remain off regard-

less of any programmed control logic until the System Off button is pushed again (on

this or any other remote control) or the “SERVICE” button is pressed on the Aqua

Logic's local display/keypad.

Please plug in to

charge battery

When the batteries are low (as shown on the battery indicator) the Aqua Pod will

alternate between this display and the normal status display. Under typical condi-

tions, there are at least 50 more one-minute uses available when this display is first

shown. The batteries will slowly lose charge if the unit is not put into the charging

stand.

Batteries dead!

Please charge now!

This display is shown briefly, immediately before the unit shuts down. The Aqua Pod

will not operate again (to protect the batteries) until it is inserted into the base charger.