ISC2028 Rev C INSTALLATION, OPERATION, & PARTS Models C2025 C3025 C4025 C5025 C7000 SWIMCLEAR™ CARTRIDGE FILTERS MODEL EFFECTIVE FILTRATION RATE DESIGN FLOW RATE Residential Commercial FT2 M2 GPM LPM C2025 225 20.9 84 318 C3025 325 30.2 122 462 C4025 425 39.5 150 568 C5025 525 48.8 150 568 C7000 680 63.2 150 568 MAXIMUM WORKING PRESSURE FOR ALL MODELS 50 PSI (3.45 BAR) ATTENTION INSTALLER: THIS MANUAL CONTAINS IMPORTANT INFORMATION ON THE OPERATION, AND SAFE USE OF THIS EQUIPMENT.
Page 2 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the following signal words and be alert to the potential for personal injury or death. WARNING Warns about hazards that could cause serious personal injury or, death, and or major property damage and if ignored presents a potential hazard.
Page 3 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C WARNING – SUCTION ENTRAPMENT HAZARD. Suction in suction outlets and/or suction outlet covers that are, damaged, broken, cracked, missing, or unsecured can cause severe injury and/or death due to the following entrapment hazards: Hair Entrapment- Hair can become entangled in suction outlet cover.
Page 4 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C GENERAL INFORMATION Your Hayward SwimClearTM cartridge filter combines superior water filtration with ease of operation and totally corrosion-free construction. With filtration ratings to 9000 gallons (34,000 liters) per hour, they are designed for continuous or intermittent operation, for installation above or below the pool water line, for fresh or salt water swimming pools or spas.
SWIMCLEAR CARTRIDGE FILTER Page 5 of 12 ISC2028 REV C STARTING THE PUMP and FILTER SYSTEM WARNING Before Starting the Pump 1. Use ONLY Hayward clamp system components; DEX2421JKIT clamp system, DEX2421J2 nut/bolt assembly, DEX2422Z2 metal reinforced seal. Non-Hayward clamp components may fail in use and cause explosive component separation. Verify that upper and lower filter bodies are properly secured with the filter body clamp. Never rely on hand tightening the clamp nut to the clamp bolt.
Page 6 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C MAINTAINING YOUR FILTER WARNING This product should be installed and serviced only by a qualified pool professional. Figure 4 FILTER DISASSEMBLY INSTRUCTIONS 1. Turn off all system circulation pumps and all electric power on the equipment pad. 2. Set all system valves in a position to prevent water flow to the filter. 3. The manual air relief valve must be placed in the OPEN position. (Fig 6) 4.
Page 7 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C FILTER RE-ASSEMBLY INSTRUCTIONS WARNING RE-INSTALLING CARTRIDGES 1. Flush and drain any dirt or debris from the bottom of the lower filter body. 2. Flush any dirt or debris from the upper filter body and from around the manual air relief area. 3. Carefully replace the cartridges over the hubs on the bottom manifold. 4. Place top closure plate securely on top of cartridges. CLEAN SEAL RING AND SEAL SURFACE 1. Remove filter tank seal. 2.
Page 8 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C REMOVING THE MANUAL AIR RELIEF VALVE WARNING This product should be installed and serviced only by a qualified pool professional. Your Filter comes with a Manual Air Relief Valve (MAR) preinstalled from the factory. For Qualified pool professionals only: If MAR valve needs to be serviced, follow these instructions carefully. 1. Turn off all system circulation pumps and all electric power on the equipment pad. 2.
SWIMCLEAR CARTRIDGE FILTER Page 9 of 12 ISC2028 REV C SERVICE AND REPAIRS Consult your local authorized Hayward dealer or service center. No returns may be made directly to the factory without the expressed written authorization of Hayward Pool Products. SUGGESTED POOL CHEMISTRY LEVELS pH 7.2 to 7.8 TOTAL ALKALINITY 80 to 120 ppm CALCIUM HARDNESS 200 to 400 ppm COMBINED CHLORINE .2 ppm Maximum CHLORINE (STABILIZED) 1.0 to 3.
Page 10 of 12 Item Part No.
Page 11 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C HAYWARD® LIMITED WARRANTY To Buyer, as original purchaser of this equipment, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its products free from defects in materials and workmanship for a period of ONE (1) year from the date of purchase.
Page 12 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C PRODUCT REGISTRATION (Retain For Your Records) DATE OF INSTALLATION ____________________ INITIAL PRESSURE GAUGE READING (CLEAN FILTER) _______________________ PUMP MODEL ________________ HORSEPOWER _______________________ FILTER MODEL ________________ SERIAL NUMBER _______________________ ▲Retain this Warranty Certificate in a safe and convenient location for your records DETACH HERE: REGISTER ONLINE AT WWW.HAYWARDNET.
