ISC2031 REV B SwimClear™ Owner’s Manual Models C2030 C3030 C4030 C5030 C7030 TOP MANIFOLD CARTRIDGE FILTERS MODEL EFFECTIVE FILTRATION RATE DESIGN FLOW RATE Residential Commercial FT2 M2 GPM LPM C2030 225 20.9 84 318 C3030 325 30.2 122 462 C4030 425 39.5 150 568 C5030 525 48.8 150 568 C7030 680 63.2 150 568 MAXIMUM WORKING PRESSURE FOR ALL MODELS 50 PSI (3.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the following signal words and be alert to the potential for personal injury or death. WARNING Warns about hazards that could cause serious personal injury or, death, and or major property damage and if ignored presents a potential hazard. CAUTION Warns about hazards that will or can cause minor or moderate personal injury and/or property damage and if ignored presents a potential hazard.
WARNING ELECTROCUTION HAZARD High Voltage electricity is present in the pool and spa equipment. High voltage electricity can cause shock and electrocution. Shock and electrocution can result in severe personal injury or death. • All electrical wiring MUST be in conformance with applicable local codes, regulations and the National Electrical Code (NEC). • Before performing any service or maintenance on electrical equipment turn off all electrical power.
GENERAL INFORMATION Your Hayward SwimClearTM cartridge filter combines superior water filtration with ease of operation and totally corrosion-resistant construction. With filtration ratings to 9000 gallons (34,000 liters) per hour, they are designed for continuous or intermittent operation, for installation above or below the pool water line, for fresh or salt water swimming pools or spas.
STARTING THE PUMP and FILTER SYSTEM WARNING Before Starting the Pump 1. Use ONLY Hayward clamp system components; DEX2421JKIT clamp system, DEX2421J2 nut/bolt assembly, DEX2422Z2 metal reinforced seal. Non-Hayward clamp components may fail in use and cause explosive component separation. Verify that upper and lower filter bodies are properly secured with the filter body clamp. Never rely on hand tightening the clamp nut to the clamp bolt.
By recording the initial starting pressure (with clean filter elements) a determination can be made when the filter cartridge elements should be replaced rather than cleaned. After the filter elements have been cleaned and reinstalled if the starting pressure is higher than 6 PSI above the starting pressure with the new filter cartridge elements, the filter cartridge elements should be replaced the next time the gauge arrow reaches the red arrow.
FILTER RE-ASSEMBLY INSTRUCTIONS WARNING RE-INSTALLING CARTRIDGES 1. Flush and drain any dirt or debris from the bottom of the lower filter body. 2. Flush any dirt or debris from the upper filter body and from around the manual air relief area. 3. Carefully replace the cartridges over the hubs on the bottom seal plate. 4. Place top manifold securely on top of cartridges, aligning the return pipe with the port in the manifold. CLEAN SEAL RING AND SEAL SURFACE 1. Remove filter tank seal. 2.
REMOVING THE MANUAL AIR RELIEF VALVE WARNING This product should be installed and serviced only by a qualified pool professional. Your Filter comes with a Manual Air Relief Valve (MAR) preinstalled from the factory. For Qualified pool professionals only: If MAR valve needs to be serviced, follow these instructions carefully. 1. Turn off all system circulation pumps and all electric power on the equipment pad. 2. Set all system valves in a position to prevent water from flowing to the filter. 3.
SERVICE AND REPAIRS Consult your local authorized Hayward dealer or service center. No returns may be made directly to the factory without the expressed written authorization of Hayward Pool Products. SUGGESTED POOL CHEMISTRY LEVELS pH 7.2 to 7.8 TOTAL ALKALINITY 80 to 120 ppm CALCIUM HARDNESS 200 to 400 ppm COMBINED CHLORINE .2 ppm Maximum CHLORINE (STABILIZED) 1.0 to 3.0 ppm CHLORINE STABILIZER (Cyanuric Acid) 60 to 80 ppm PROBLEM SOLVING LIST REMEDY LOW WATER FLOW 1.
Item Part No.
HAYWARD® LIMITED WARRANTY To Buyer, as original purchaser of this equipment, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its products free from defects in materials and workmanship for a period of ONE (1) year from the date of purchase.
Page 12 of 12 ▲ SWIMCLEAR™ CARTRIDGE FILTER ISC2031 REV B Retain this Warranty Certificate in a safe and convenient location for your records PRODUCT REGISTRATION (Retain For Your Records) DATE OF INSTALLATION ____________________ INITIAL PRESSURE GAUGE READING (CLEAN FILTER) _______________________ PUMP MODEL ________________ HORSEPOWER _______________________ FILTER MODEL ________________ SERIAL NUMBER _______________________ DETACH HERE: Fill out bottom portion completely and mail within 10