User Guide
Table of Contents
OPERATIONOPERATION
OPERATIONOPERATION
OPERATION
GeneralGeneral
GeneralGeneral
General.........................................................................................1
Water ChemistryWater Chemistry
Water ChemistryWater Chemistry
Water Chemistry........................................................................2
ControlsControls
ControlsControls
Controls........................................................................................6
Information MenuInformation Menu
Information MenuInformation Menu
Information Menu.......................................................................7
Settings MenuSettings Menu
Settings MenuSettings Menu
Settings Menu..............................................................................9
OperationOperation
OperationOperation
Operation...................................................................................11
MaintenanceMaintenance
MaintenanceMaintenance
Maintenance...............................................................................12
INSTALLATIONINSTALLATION
INSTALLATIONINSTALLATION
INSTALLATION
MountingMounting
MountingMounting
Mounting.......................................................................................13
PlumbingPlumbing
PlumbingPlumbing
Plumbing......................................................................................14
WiringWiring
WiringWiring
Wiring..........................................................................................15
TROUBLESHOOTINGTROUBLESHOOTING
TROUBLESHOOTINGTROUBLESHOOTING
TROUBLESHOOTING
TroubleshootingTroubleshooting
TroubleshootingTroubleshooting
Troubleshooting.......................................................................18
WARRANTYWARRANTY
WARRANTYWARRANTY
WARRANTY
WarrantyWarranty
WarrantyWarranty
Warranty....................................................................................20
19
• High Salt/Amps/Minerals -- The Aqua Rite Pro will stop generating chlorine under
certain high salt conditions in order to protect the internal electronics from damage.
The only way to lower the salt level is to partially drain the pool and add fresh water.
• Chlorinator Cell Sensor -- The cell sensor is either an open or short circuit.
• Low Volts -- If the chlorinator cell voltage is too low.
• No Cell Power -- If no chlorinator cell power is detected on the printed circuit board.
• Check Flow Switch -- If the flow switch input is invalid.
• Cell Power Error -- If a chlorinator cell power error is detected on the printed circuit
board.
• Cell Missing -- If the chlorinator is enabled but no cell is detected.
• CSM Comm Error: -- If Chemistry Sensing is enabled and the Chemistry Sense
Module (CSM) is not responding.
• pH Probe Error -- If the CSM indicates that there is a problem with the pH probe.
• pH Low - Check Feeder -- If a pH level of 6.9 or less is detected, check the feeder for
proper operation
• pH High - Check Feeder -- If a pH level of 8.1 or higher is detected, check the
chemical supply and the feeder for proper operation
• pH Timeout - Check Feeder -- If the unit has been dispensing for more than the
selected timeout without reaching the desired level. Check the chemical supply and
the feeder. If both are OK, the timeout may need to be increased. Press the “+”
button to reset the alarm and resume dispensing.
• pH Calibration Error -- When using the pH Calibration Wizard and the entered test
result was different from the measured pH level by ± 1.0 or more. The pH probe may
need to be cleaned or replaced.
• ORP Probe Error -- If the CSM indicates that there is a problem with the ORP probe.
• ORP Low - Check Chlor -- If an ORP level of 350mV or less is detected. Check the
chlorinator for proper operation.
• ORP High - Check Chlor -- If an ORP level of 950mV or higher is detected. Check the
chlorinator for proper operation.
• ORP High - Chlor Off -- If an ORP level of 950mV or higher is detected and the
chlorine feed mode is ORP Auto Sensing, the chlorinator has been turned off. Check
the chlorinator for proper operation.
• ORP Timeout -Chlor Off -- If the unit has been chlorinating for more than the
selected sanitizer timeout without reaching the desired level, the chlorinator has
been turned off. Press the “+” button to reset the alarm and resume chlorination.
• Ambient Sensor -- If the internal (ambient) sensor is either open or short circuit.