User Manual

ManualsBrandsHayward ManualsParts & AccessoriesHayward GLX-PL-LOC-P-4 Local Display Replacement for Hayward PL-P-4 Goldline Pro Logic Automation and Chlorination

General Purpose Outlet

If desired, a duplex receptacle with weatherproof cover (supplied by installer) may be installed in the

knockouts on the lower right side of the Pro Logic enclosure. Per code, the receptacle should be a GFCI

type. Alternatively, connect a standard receptacle to a GFCB.

Pro Logic Control Power

The Pro Logic requires 120VAC, 2A power to operate the control logic circuits and the chlorinator. This

power should be connected to one of the circuit breakers.

WARNING: 120VAC only (permanent damage if connected to 240V)

Remote Display/Keypad

The Pro Logic main unit can connect to a maximum of 3 remote wired display/keypads (ordered sepa-

rately).

Use four conductor cable (typically phone cable) to connect the wired remote display/keypad with the Pro

Logic Control Center as shown below. The maximum wiring distance is 500ft. (160m). Note that the

terminals on both the Pro Logic main unit and the wired remote display/keypad are numbered: Connect 1

to 1, 2 to 2, etc. Refer to diagram below.

If multiple remote display/keypads are installed: Never connect more than 2 wires to any terminal

block. Two remotes can be wired back to the Pro Logic main unit or the second display/keypad (and

third, if applicable) can be “daisy chained” with one display/keypad wired to the next. The maximum wire

run from the Pro Logic main unit to the furthest remote display/keypad is 500 ft (160m).

Base Station

Plug in the pigtail connector from the wireless base station into the “wireless” connector on the main PCB

in the Pro Logic control unit.

Cutler-Hammer

Murray

Siemens

Square D

Thomas & Betts

Manufacturer

Single

Double

Quad

Twin

GFCB

Filler Plates

MP-T

HOM

MP-T

HOM

BRD

MH-T

HOMT

TBBD

BRD

MH-T

HOMT

TBBQ

GFCB

MP-GT

QPF

HOM

GFB

BRFP

LX100FP

QF3

HOMFP

FP-1C-TB

SUITABLE LISTED BREAKERS

Factory

Prewired

Field

Wired

120, 2VA

Base Station

(AQL2-BASE-RF)

Tighten nut

Pro Logic

Main PCB

Connector for

Base Station

Remote Display unit

Alternative

Concealed Wiring

500 ft max

3.75

”

4.50

”