User Manual

ManualsBrandsHayward ManualsOutdoorsH-Series 150,000 BTU In-Ground Natural Gas Pool Heater

FOR YOUR SAFETY

WARNING: If the information in these

instructions is not followed exactly, a ﬁre

or explosion may result causing property

damage, injury, or death.

- Donotstoreorusegasolineorotheram-

mablevaporsorliquidsinthevicinityofthis

oranyotherappliance.

WHAT TO DO IF YOU SMELL GAS:

• Donottrytolightanyappliance.

• Donottouchanyelectricalswitch;donotuse

anyphoneinyourbuilding.

• Immediatelycallyourgassupplierfroma

neighbor’sphone.Followthegassupplier’s

instructions.

• Ifyoucannotreachyourgassupplier,callthe

redepartment.

-Installationandservicemustbeperformedby

aqualiedinstaller,serviceagency,orthegas

supplier.

POOL AND SPA/HOT TUB HEATERS

H150FD, H200FD, H250FD, H300FD,

H350FD & H400FD MODELS

OWNER’S MANUAL

FOR YOUR SAFETY

Thisproductmustbeinstalledandservicedbyauthorizedpersonnel,qualiedinpool/spa

heaterinstallation.Improperinstallationand/oroperationcancreatecarbonmonoxidegas

anduegasesthatcancauseseriousinjury,propertydamage,ordeath.

1301640701 REV F 0413

PRINTED 10/24/2011 AT 1:13 PM

U.S. PATENT NOS. 6,026,804, 6,321,833, & 7,971,603

Summary of content (16 pages)

PAGE 1
POOL AND SPA/HOT TUB HEATERS H150FD, H200FD, H250FD, H300FD, H350FD & H400FD MODELS OWNER’S MANUAL FOR YOUR SAFETY WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, injury, or death. PRINTED 10/24/2011 AT 1:13 PM - Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS: • • Do not try to light any appliance.
PAGE 2
CONTENTS Warnings........................................................................................................3 Section I. General information........................................................................7 Section II. Consumer Operation & Maintenance............................................8 Maintaining proper water chemistry...............................................................8 Lighting & Operating instructions label.....................................................
PAGE 3
SAFETY INFORMATION Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe injury and/or death. This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the following signal words and be alert to the potential for personal injury. WARNING warns about hazards that could cause serious personal injury, death or major property damage and if ignored presents a potential hazard.
PAGE 4
NOTES TO THE ELECTRICIAN: Use a solid copper conductor, size 8 or larger. Run a continuous wire from external bonding lug to reinforcing rod or mesh. Connect a No. 8 AWG solid copper bonding wire to the grounding lug provided on the heater and to all metal parts of swimming pool or spa, and to all electrical equipment, metal piping (except gas piping), and conduit within 5 ft. (1.5 m) of inside walls of swimming pool or spa.
PAGE 5
WARNING – Failure to remove pressure test plugs and/or plugs used in winterization of the pool/spa from the suction outlets can result in an increase potential for suction entrapment as described above. WARNING – Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair, paper and other material can result in an increase potential for suction entrapment as described above.
PAGE 6
WARNING – The following “Safety Rules for Hot Tubs” recommended by the U.S. Consumer Product Safety Commission should be observed when using the spa. 1. Spa or hot tub water temperatures should never exceed 104°F [40°C]. A temperature of 100°F [38°C] is considered safe for a healthy adult. Special caution is suggested for young children. Prolonged immersion in hot water can induce hyperthermia. 2.
PAGE 7
SECTION I. GENERAL INFORMATION INTRODUCTION: This manual contains instructions for operation and the safe use of the swimming pool/spa/hot tub heaters. Hayward strongly recommends that the owner read the manual before using the swimming pool/spa/ hot tub heater. If after reviewing the manual any questions remain unanswered, contact the factory or local representative.
PAGE 8
SECTION II. CONSUMER OPERATION & MAINTENANCE MAINTAINING PROPER WATER CHEMISTRY WARNING: Failure to Maintain Proper Water Chemistry May Cause Premature Heat Exchanger Damage or Failure The heat exchanger in your Hayward pool heater is made from the highest quality of copper and nickel (Cupronickel) materials. The premium materials and the exacting processes used in the manufacture of the heat exchanger is state of the art in pool heater design and manufacture.
PAGE 9
4. CHLORINATOR INSTALLATION Chlorinators must be installed downstream of the heater, and a check valve must be installed between the heater and chlorinator to prevent high chemical concentrations from back flowing into the heater. Make sure your piping arrangement meets the chlorinator installation requirements shown in the installation manual on page 26. 5.
PAGE 10
Figure 2: Lighting & Operating Instructions label USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville,TN Tel: 908-351-5400 www.haywardpool.
PAGE 11
TEMPERATURE ADJUSTMENT This pool heater is equipped with a digital thermostat which allows the user to select the desired water temperature. The heater will then function automatically to maintain the desired temperature. The heater has 3 modes of operation: 1. STANDBY: in this mode, the heater will not function to heat the water. 2. SPA: in this mode, the heater will automatically function to maintain the water temperature setting for SPA mode. 3.
PAGE 12
TEMPERATURE LOCK-OUT: The digital thermostat in this pool heater allows the user to lock the maximum temperature setting allowed. This feature is useful for preventing unauthorized users from manually adjusting the temperature settings higher than desired. On a new heater, the maximum allowed temperature lock settings are initially set at the factory to 90°F for POOL mode, and 104°F for SPA mode. To adjust these settings, use the following procedure: 1.
PAGE 13
ERROR CODES: Figure 4 lists the error codes that may be displayed on the heater display board. Contact a qualified service company for assistance. Figure 4: ERROR CODES Code Description Information Internal fault/power-up error On initial trial for ignition. Automatic reset is immediate once the gas valve relay check results are acceptable. bD Gas valve sensed as “ON” error If valve is open when it should be closed the heater will shut down and go into lockout.
PAGE 14
Figure 4: ERROR CODES (continued) Code IO Description Information Igniter open error If the control is not in lockout and senses that the igniter circuit is open when the blower is running the control will turn off the blower and go into lockout. Automatic restart 2 min after error is corrected.
PAGE 15
HAYWARD POOL HEATER CERTIFICATE OF LIMITED WARRANTY Limited heater warranty: TERMS AND COVERAGE: We warrant our pool heater to be free from defects in workmanship and materials under normal use and service. Pursuant to this warranty and subject to the Conditions and Exceptions indicated below: 1.
PAGE 16
HAYWARD POOL HEATER CERTIFICATE OF LIMITED WARRANTY (CONTINUED) Do not install this product where such leakage can cause damage. MANUFACTURER IS NOT RESPONSIBLE OR LIABLE FOR ANY COSTS INCURRED BY SUCH DAMAGE. IN NO CASE ARE WE TO BE HELD LIABLE FOR DAMAGE TO SURROUNDING AREA OR PROPERTY CAUSED BY LEAKAGE OR MALFUNCTION.