Instructions / Assembly

ManualsBrandsHayward ManualsOutdoors1/2 HP Super Pool Pump

ISSPSERIES Rev D

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 1

Super Pump

Series

Owner’s Manual

IMPORTANT SAFETY INSTRUCTIONS

The Hayward Super Pump

is specifically engineered for the demanding requirements of today’s in-ground swimming

pool/spa that is equipped with large capacity filters, heaters, and pool cleaning equipment. The Super Pump

is a self-

priming pump that incorporates a seal and impeller design that will provide many years of efficient, dependable, corrosion-

free service. The advanced design provides superior performance while reducing maintenance requirements.

Basic safety precautions s

ways

e fo

owe

, inc

ing t

e fo

owing: Fai

ure to fo

ow instructions

can cause severe injury and/or death.

This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for

one of the following signal words and be alert to the potential for personal injury.

WARNING warns about hazards that could cause serious personal injury, death or major property

damage and if ignored presents a potential hazard.

CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or

property damage and if ignored presents a potential hazard. It can also make consumers aware of

actions that are unpredictable and unsafe.

The NOTICE label indicates special instructions that are important but not related to hazards.

Hayward Pool Products

620 Division Street, Elizabeth, NJ 07207

Phone: (908) 355-7995

www.hayward.com

Contents

Product Specific Warnings………2

Introduction……….………………..…4

Installation……….……………..….….7

Shaft Seal Replacement..………..8

Replacement Parts………….……….9

Trouble Shooting………….…..……10

Warranty…………………………………11

Registration ……………………………12

Summary of content (12 pages)

PAGE 1
ISSPSERIES Rev D Super Pump Series ® Owner’s Manual Contents Product Specific Warnings………2 Introduction……….………………..…4 Installation……….……………..….….7 Shaft Seal Replacement..………..8 Replacement Parts………….……….9 Trouble Shooting………….…..
PAGE 2
WARN NING – Read d, understa and, and fo ollow all insstructions in this owner’ss manual and oon the eq quipment. Failure to follow instructions ca an cause severre injury and/o or death. WARN NING – Suction Entrapmeent Hazard. Suction in suction s outlets and/or suction n outlet covers which w are, dam maged, broken, cracked, missing, or unsecure ed can cause severe injury and/or death h due to the following entrapm ment hazards: Hair Entrapment- Hair ca an become enta angled in suctio on outlet cover..
PAGE 3
WARNING – Risk of Electric Shock. All electrical wiring MUST be in conformance with applicable local codes, regulations, and the National Electric Code (NEC). Hazardous voltage can shock, burn, and cause death or serious property damage. To reduce the risk of electric shock, do NOT use an extension cord to connect unit to electric supply. Provide a properly located electrical receptacle. Before working on any electrical equipment, turn off power supply to the equipment.
PAGE 4
General Information Introduction This manual contains information for the proper installation and operation of the Hayward Super Pump® Series. The instructions in this manual MUST be followed precisely. Failure to install according to defined instructions will void warranty. Product Benefits         Super-sized 110 cubic-inch basket has extra leaf-holding capacity and extends time between cleanings.
PAGE 5
Pump Mounting Install pump on a firm, level base or pad to meet all local and national codes. Fasten pump to base or pad with screws or bolts to reduce vibration and stress on pipe or hose joints. The base MUST be solid, level, rigid, and vibration free. Pump mount must:  Allow pump inlet height to be as close to water level as possible.  Allow use of short, direct suction pipe (to reduce friction losses).  Allow for ball valves in suction and discharge piping.
PAGE 6
Use copper conductors only. MOTOR KW HP .37 1/2 .55 3/4 .75 1 1.1 1-1/2 1.55 2 1.88 2-1/2 ELECTRICAL GUIDE – 60 CYCLE MOTORS – SINGLE PHASE CIRCUIT BREAKER BRANCH FUSETRON VOLTS RATINGS-AMPS RATINGS-AMPS 115 15 15 115 15 15 230 10 6.25 115 20 20 230 10 9 115 30 30 230 15 15 115 30 30 230 15 12 230 20 20 RECOMMENDED WIRE SIZE 0-50’ No. 14 No. 14 No. 14 No. 12 No. 14 No. 10 No. 14 No. 10 No. 14 No.
PAGE 7
NOTICE – NEVER OPERATE THE PUMP WITHOUT WATER. Water acts as a coolant and lubricant for the mechanical shaft seal. NEVER run pump dry. Running pump dry may damage seals, causing leakage, flooding, and voids warranty. Fill strainer housing with water before starting motor. NOTICE – Do NOT add chemicals to pool/spa system directly in front of pump suction. Adding undiluted chemicals may damage pump and voids warranty. NOTICE – Before removing strainer cover: 1. STOP PUMP before proceeding. 2.
PAGE 8
Shaft Seal Change Instructions IMPORTANT SAFETY INSTRUCTIONS PLEASE READ AND FOLLOW ALL INSTRUCTIONS WARNING – Electrical Hazard - Failure to disconnect power may result in serious personal injury or death. To avoid, turn OFF power to motor before servicing pump. NOTICE- Only qualified personnel should attempt rotary seal replacement. Contact your local authorized Hayward Dealer or service center if you have any questions.
PAGE 9
Replacement Parts Parts Diagram Parts Listing PART NUMBER REFERENCE NUMBER DESCRIPTION NUMBER REQUIRED MODEL SP2600X5 MODEL SP2605X7 MODEL SP2607X10 MODEL SP2610X15 MODEL SP2615X20 MODEL SP2621X25 1 2 3 4 5 6 7 8 9 10 11 HAND KNOB SWIVEL NUT STRAINER COVER STRAINER COVER GASKET BASKET DRAIN PLUG W/ GASKET PUMP/STRAINER HOUSING DIFFUSER GASKET DIFFUSER IMPELLER SEAL ASSEMBLY 2 2 1 1 1 2 1 1 1 1 1 SPX1600P SPX1600N SPX1600D SPX1600S SPX1600M SPX1700FG SPX1600AA SPX1600R SPX2600B SPX2600C SPX1600Z
PAGE 10
Troubleshooting Motor Will NOT Start – Check For: Make sure the terminal board connections agree with the wiring diagram on motor data plate label. Be sure motor is wired for available field supply voltage. 1. Improper or loose wiring connections; open switches or relays; tripped circuit breakers, GFCI’s, or blown fuses. Solution: Check all connections, circuit breakers, and fuses. Reset tripped breakers or replace blown fuses. 2.
PAGE 11
Low Flow – Generally, Check For: 1. Clogged or restricted strainer or suction line. Solution: Contact a qualified repair professional. 2. Undersized pool piping. Solution: Correct piping size. 3. Plugged or restricted discharge line of filter, valve partially closed (high gauge reading). Solution: Sand filters – backwash as per manufacturer’s instructions; D.E. filters – backwash as per manufacturer’s instructions; Cartridge filters – clean or replace cartridge. 4.
PAGE 12
DETACH HERE: H Fill out bottom portion com mpletely and mail within 10 days of purchase/insstallation or reg gister online. -------------------------------------------------------------------------------------------------------------------------------------------------------- Su uper Pum mp® Serie es Wa arranty C Card Registration n Register R onlin ne at www.haayward.