Assembly Instructions 24 qt. Bucket with Wringer Model #24QSPW 1. Check carton contents for all assembly parts (Fig. A): 0 24-quart mop bucket 0 Bag with 4 non-marking, 2” castor wheels g and 1 plastic handle pin 0 Side press wringer assembly 0 Wringer handle O Bucket handle Removable bucket divider 2, Attach the wheels on the mop bucket by placing the bucket’s open side down on a level surface and inserting the barbed end of each of the four (4) castor wheels into the holes on the bottom of the mop bucket.
4, Attach the wringer handle to the wringer assembly by placing it into one of the two steel handle receptacles (your preference) and aligning the per-drilled hole in the handle with the hole in the steel handle holder. (Fig. E) The slight bend in the handle will angle upwards. (Fig. F) 5. Secure the handle by Inserting the plastic handle pin into the aligned holes of wringer handle and steel holder. (Fig. G & H) Fig.G Fig.
6. Attach the mop bucket handle by inserting the ends of the handle into the holes on either side of the mop bucket (shorter sides). (Fig. ) Fig. | Bucket Handle Bucket Handle Installed on Wringer Installed on Opposite Side of Bucket Side of Bucket 7. To separate dirty from clean water inside the mop bucket, prior to filling with water, attach the bucket divider by sliding the divider into the interior channels in the middle of the bucket. (Fig. J &K) Fig.J Fig.