User's Manual

ManualsBrandsHBC-radiomatic ManualsElectronicsCrane Remote Control Transmitter

Operating Instructions

Radio Transmitter micron 4 Industrial

BE-MICR4_I-V2-2.DOC [ Word 97 ] FL Page 11 / 18

HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY

Information and specifications subject to change without notice. 2000-08-15

Radio System

3.2 Special Operating Modes (Optional)

This chapter describes special operating modes that are not available with all crane

systems.

If your radio control system is not equipped with the features described, you may ignore

the following and continue with the next chapter.

3.2.1 Pitch – Catch

The "Pitch – Catch" operating mode

allows two or more crane operators

equipped with one transmitter each to

independently use the same crane.

The crane is equipped with a radio

receiver that can receive and monitor

transmitter frequencies.

After activating the receiver all

transmitters have equal access to the

control system.

Releasing the crane ("Pitch")

To release the crane :

1. Turn rotary switch (pos. Á) on

transmitter 1 or transmitter 2 to the

"Pitch" position.

2. For safety reasons we recommend switching OFF

transmitter 1 or transmitter 2 (pos. À). This will avoid

operator errors.

The respective transmitter 1 or transmitter 2 now has no

access to the crane control system.

Taking over control of the crane ("Catch")

To take over the control of the crane turn the rotary

switch (pos. Á) on transmitter 1 or transmitter 2 to the

"Catch" position.

The transmitter with control over the crane retains the

access to the receiver (transmitter 1 or transmitter 2) until

the operator has issued the "Pitch" statement.

Example :

Transmitter 2 has control over the crane control system.

Transmitter 1 is to be given control. The operators must

continue as follows :

1. Turn rotary switch (pos. Á) on transmitter 2 to the "Pitch" position.

2. For safety reasons deactivate transmitter 2, i.e. turn the key switch (pos. À) to the

"0 = OFF" position.

3. Activate transmitter 1, i.e. turn the key switch (pos. À) to the "1 = ON" position.

4. Turn the rotary switch (pos. Á) on transmitter 1 to the "Catch" position.

Transmitter 1 now has sole access to all crane functions.

Crane receiver with

2 reception frequencies

File: C_R-MI.CDR [CorelDraw 6.0] 01-17-2000 FL

"Catch" and "Release"

Transmitter 1 Transmitter 2

micron

made by HBC

0 1

31.394

PITCH CATCH

Trolley

1 1+2 2