User's Manual

Operating Instructions
Radio Transmitter micron 4 Industrial
Page 8 / 18 BE-MICR4_I-V2-2.DOC [ Word 97 ] FL
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
2000-08-15 Information and specifications subject to change without notice.
Radio System
3 Operation
1. Before commissioning the transmitter or initial
operation, insert the FuB 3A battery into battery
compartment at the back of the transmitter
(inscription must be visible). The battery supplies
the necessary working voltage (6 V DC).
2. Pull STOP pushbutton (pos. À) to unlock.
3. Turn key switch (pos. Á) to the right (position "1").
4. Switch ON transmitter and crane or machine with
"ON/Horn" (pos. Â) pushbutton. The green LED
(pos.Ã) begins to flash, i.e. the transmitter is
operable.
Important Information :
After switching ON the transmitter and before
operating the crane or machine you must always :
– trigger the acoustic signal by pressing the button
"ON/Horn (pos. Â). This warns all colleagues
that the crane or machine is about to move;
– test the operativeness of the STOP pushbutton.
After switching on the transmitter the instrument
indicates a successful radio link to the receiver when
the red LED "HF/RF/H.F./HF" extinguishes and the
green LED "Si" lights up (refer to control light panel on
receiver). The radio control system is ready for use. The
operator can now issue control commands using the
transmitter control elements.
When the battery is nearly empty, the red LED (pos. Ã)
lights up or an acoustic signal sounds. The drained
battery must be immediately replaced by a fully
charged battery and then inserted into the battery charger for recharging (refer to
chapter "Battery and Battery Charger" for further details).
Note :
The transmitter will automatically switch OFF within a few minutes if the operator fails
to replace the drained battery.
Should the operator – intentionally or unintentionally – switch OFF the transmitter with
the STOP pushbutton, proceed as follows to restart the transmitter :
1. Pull STOP pushbutton (pos. À) to unlock.
2. Switch transmitter ON with the "ON/Horn" pushbutton (pos. Â).
Note :
Always use the key switch (pos. Á) to switch the transmitter ON or OFF. Do not
use the STOP pushbutton !
STOP
micron
made by HBC
0 1
31.394
PITCH CATCH
Trolley
1 1+2 2
22
11
À
Á
Â
Ã
File: MICRON4-I.CDR [ CorelDraw 8.0 ] 2000-06-19 FL