User's Manual

Operation
The transmitter is equipped with an electronic radiomatic
®
iLOG key. radiomatic
®
iLOG contains all the
data required for operating the transmitter. Operation is not possible without radiomatic
®
iLOG!
Depending on the version the radiomatic
®
iLOG can also be used for operation of replacement
transmitters of identical construction.
In the event of an interruption of the radio link during a working cycle – what can occasionally happen –
both transmitter and receiver automatically shut down (so-called "compulsory switch-off").
To reactivate the system release all operator controls and allow the control elements to return to their
zero position. After that the machine can react again to control commands. This feature hinders any
uncontrolled or unwanted machine movement, should the radio link be interrupted.
Note:
If the machine is equipped with a main contactor you must actuate the start button before the
machine can react again to control commands.
Activating the Transmitter
With start sequence
Insert a charged battery into the battery compartment.
The following steps need to be carried out within 4 seconds:
1. Pull the STOP switch.
2. Shortly actuate the start button and then release. The transmitter will
switch off if the button is pressed for longer than half a second!
3. Actuate the start button again until the status LED flashes green. Then
release the button.
The transmitter is now ready for operation.
Note:
The transmitter switches off when
 the start button is actuated for longer than half a second (see
above, point 2).
 switching on takes over 4 seconds.
 another button is pressed when switching on.
You must then press the STOP switch and repeat steps 1 to 3.
With HBC Smart Card
1. Insert a charged battery into the battery compartment.
2. Pull the STOP switch.
The status LED flashes green 2 times and red 1 time per
second.
3. Hold the HBC Smart Card in front of the transmitter (see
illustration).
The transmitter vibrates and an acoustic signal sounds.
When the status LED flashes green, the transmitter is ready to
operate.
If an invalid HBC Smart Card is used, the transmitter vibrates
3 times. At the same time an acoustic signal sounds. Then the
transmitter switches off.
 STOP-switch
 Start button
 Status LED
 radiomatic
®
iLOG