User Manual

Operating Instructions
Radio Transmitter spectrum 3 M
Page 12 / 22 BE-SP3M-V2-3.DOC [ Word 2000 ] FL/US
HBC-radiomatic GmbH • D-74564 Crailsheim • Germany
2002-12-03 Information and specifications subject to change without notice.
Radio Control System
3.2 Special Operating Modes ( Optional )
Note :
This chapter describes special operating modes that are not available with all crane
systems.
If your radio control system is not equipped with the features described, you may ignore
the following and continue with the next chapter.
3.2.1 Option Scanner ( Frequency Selector )
Note :
This is a standard function by radio control systems for construction cranes, and
available as an option by radio control systems for industrial cranes.
The transmitter and receiver are equipped with a "Scanner" (frequency selector)
operating mode with 4 radio frequencies (refer to wiring diagrams).
In the event that the momentarily used radio channel is being used by another operator,
the transmitter can be switched over to a different channel by means of the rotary
switch. The receiver scanner automatically adjusts the receiver to the selected radio
frequency.
After turning ON the transmitter (set key switch to "ON" position and do not forget to
unlock STOP pushbutton), the receiver automatically resets the system to the new
frequency selected in less than a second.