User Manual

Operating Instructions
Radio Transmitter spectrum 3 M
BE-SP3M-V2-4(FCC).doc [ Word 2000 ] FL/US/MB Page 15 / 22
HBC-radiomatic GmbH • D-74564 Crailsheim • Germany
Information and specifications subject to change without notice. 2003-02-12
Radio Control System
Tandem Operation TM / TS
Operation of two cranes is possible
with two complete radio controls
(2 transmitters, 2 receivers) using the
option tandem operation "TM / TS",
whereby one transmitter is a "master"
and the other transmitter is a "slave".
The radio transmitter key for crane B
can also be used to switch over the
transmitter for crane A to crane B.
To do this, the following steps must
be carried out :
1. Remove the key from the slave
transmitter. This switches OFF
the slave transmitter.
2. Put the key from slave transmitter
into master transmitter.
This activates the release for crane pre-selection in the transmitter.
3. Select the corresponding crane by means of the rotary switch on the master
transmitter : either crane A or crane A+B (both cranes) or crane B.
The corresponding cranes are now running in the pre-selected operation mode.
Note :
To ensure safe operation during tandem operation "T2" and "TM / TS", it is imperatively
required that only one key is available to the respective crane operators.
The extra key supplied with transmitter 2 must therefore be deposited at a superior,
authoritative position and only be handed out in clarified cases.
Transmitter key 2
Crane B / receiver 2 with
2 reception frequencies,
address 2
Crane A / receiver 1
with 1 reception frequency,
address 1
File:
TANDEM_TM_SP.CDR [ CorelDraw 8.0 ] 2000-11-06 FL
Master transmitter Slave transmitter