User's Manual

Operating Instructions
Radio Transmitter PM NTU
Page 12 / 16 BE-PM_NTU-US-L.DOC [ Word 97 ] FL
HBC-radiomatic, Inc. , Cincinnati , Ohio 45242 , USA
2000-08-16 Information and specifications subject to change without notice.
Radio Control System
Programming
1. Switch OFF the transmitter.
2. Insert a charged tele-teach-in battery (TTB 10) into the transmitter.
3. Depress the programming keys "+" and "–" simultaneously and then switch ON the transmitter.
Keep the programming keys depressed until the green service LED of the transmitter starts
flashing quickly. Now, the control is in the tele-teach-in mode.
4. Setting the minimum speed (fig. right)
Push the joystick toward the desired function.
Note :
Do not move the lever of the joystick beyond 50% of the maximum lever
travel.
Then adjust the minimum speed by means of the "+" and "–" keys, i.e. by looking for the
minimum point when the hydraulic valve begins to react. It will be helpful to observe the way
the function is carried out as well as the movement of the lever of the hydraulic valve (fig.
above).
5. Setting the maximum speed (fig. right)
Push the joystick toward the desired function by moving it to its end
position. Then adjust the maximum speed by means of the "+" and "–"
keys, i.e. by looking for the maximum point when the hydraulic valve
begins to react. In order to make use of the full lever travel of the
joystick, do not actuate the "+" key any longer after the hydraulic valve
has reached its maximum travel (fig. right).
Note :
In the tele-teach-in mode, only execute one single function at the time, not both joysticks in a
diagonal way, as it is only possible to program one single function at the time.
For all further joystick functions, please repeat the steps beginning with item 3.
In order to verify the programmed settings, switch OFF the transmitter and then switch it ON
afterwards. Now, the transmitter is again in the normal operating mode.
In case of systems that offer creeping function, all the functions will have to be programmed again
in the creeping mode (switch set to the snail symbol).
min.
max.