User's Manual

Integration instructions for host product manufacturers according to KDB 996369 D03
OEM Manual v01
2.2 List of applicable FCC rules[and ISED Radio Standards Specifications]
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter
in a host, host manufacturer have to consult with module manufacturer for the installation
method in end system.
2.4 Limited module procedures
This module is Limited single modular without shielding, host manufacturer have to consult
with module manufacturer for the module limiting conditions when integrate the module in the
host. module manufacturer should reviews detailed test data or host designs prior to giving the
host manufacturer approval.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The device has been evaluated to meet general RF exposure requirement in portable
exposure condition without restriction.
2.7 Antennas
This radio transmitter FCC ID: 2AEJQHC-42 has been approved by Federal Communications
Commission to operate with the antenna types listed below, with the maximum permissible
gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna No.
Operate frequency band
Antenna Type
Maximum antenna
gain
Antenna 1
2.4GHz – 2.5 GHz
PCB Antenna
0.0 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:
FCC ID: 2AEJQHC-42”
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC requirements for
the transmitter when the module is installed in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with
all other applicable requirements for the system such as Part 15 B.
Page 19