User guide

Page | 16

F. Remote Control:

This feature allows the user to send a text message command to change the Send Mode.

Once this function is enabled, user needs to input a Receive Time as shown below.

The camera GSM module will boot up automatically every day at the ‘Receive Time’ to

check if there is any text message commands. After processing the text message

command, the camera will send a confirmation text message to the sender phone

number. If multiple commands are received, the camera will only process the last text

message command.

Note: Avoid sending multiple text message commands to camera in one day.

The camera will accept text message commands in the following protocols shown in the

table:

Send Mode

Text Message Command Protocol

Example

Off

C#00#E

Instant

C#01#NNN#E

C#01#008#E

Customized

C#02#HHMM#NN#E

C#02#0930#05#E

Daily Report

C#03#HHMM#E

C#03#1230#E

HH means hour, MM means minute, NN or NNN mean Max Number. Taking

"C#02#0930#05#E" for example, this command will change the Send Mode to "Custom"

with receiving time at 9:30 and Max Num. 5.