User's Guide

ManualsBrandsHCS ManualsElectronicsRemote control

User guide for Remote Control RC3394003/01BR

The remote control has been programmed to control your set-top box and can be

programmed to control your TV.

Installing Batteries

The remote requires 2xAAA batteries. A diagram inside the battery compartment of the

remote indicates proper placement of the batteries. When batteries are properly

installed, the light on the remote blinks each time a key is pressed

Know your Remote

The diagram below describes each key on your remote control. Functions may vary

between different services. Refer to the user guide for your set-top box for descriptions

of specific functions.

Summary of content (7 pages)

PAGE 1
User guide for Remote Control RC3394003/01BR The remote control has been programmed to control your set-top box and can be programmed to control your TV. Installing Batteries The remote requires 2xAAA batteries. A diagram inside the battery compartment of the remote indicates proper placement of the batteries. When batteries are properly installed, the light on the remote blinks each time a key is pressed Know your Remote The diagram below describes each key on your remote control.
PAGE 2
PAGE 3
Product Introduction 1) This RCU is transmitting IR and RF. There is a simple set up feature for TV/Home Theatre device. 2) The RCU can be set-up to control a RF or an IR STB (mutually exclusive). 3) The RF platform is BLE, using HOGP as the top layer. Before the RCU can control the STB, the RCU must pair with the STB first.
PAGE 4
) The IR protocol to control the STB is NEC. When RCU is not connected to any STB via BLE, MCU use IR to control STB. 5) When BLE is not connected, all the STB IR keys are transmitted through NEC IR protocol. Custom ID is 0x1620. Set STB Control Medium 1) Set to IR Mode: Press <
> simultaneously for 3 seconds. 2) Set to RF Mode: Press <> simultaneously for 3 seconds; 3) Set dual-function Keys as TV Keys Press << OK + 3>> simultaneously for 3 seconds; 4).
PAGE 5
The OTA process can be triggered by the user using the RCU or by the STB itself. The RCU OTA IMAGE need to be downloaded into the STB itself. After the OTA is completed, the RCU will have a new firmware. Simple Setup 1) Simple Setup is a feature helps user to automatically set up the remote control via STB. After being set by Simple Setup, the RCU will be able to control TV/AMP. 2) Below IR function could be configured to control TV through simple setup: TV Power, TV input, TV Mute, TV Vol+ and TV vol-.
PAGE 6
FCC ID:2AGOFRC339A This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 7
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence.