User manual

7
About Player
Getting Started
 Remove the transparent protecting film from the front panel of the player to ensure good
look of the player.
 Ensure the RC has batteries installed.
 Connect the player to your TV and to other A/V equipment in an appropriate way. Use
HDMI connection to get the best possible quality of video and audio. Make sure to switch off
the player and all relevant A/V equipment before connecting them. Ensure your TV and other
A/V equipment are configured to use proper inputs.
 When you switch on the player for the first time, the player will perform its initial loading
procedure, which may take some time (usually up to 30 seconds). During the loading proce-
dure, "DUNE" logo is shown on the TV.
● If you do not see "DUNE" logo on the TV when you switch on the player, it may mean
some problem with the connection between the player and the TV or that a wrong video
input is chosen in the TV or A/V receiver/switch. In such a case, recheck the cables and
the settings of the TV or A/V receiver/switch, or try to use different cables or a different
way of connecting the player to the TV.
● If you see "DUNE" logo on the TV when you switch on the player, but then the picture
disappears and no other picture appears during at least 10 seconds, it may mean that a
wrong video output mode is configured in the player. In such a case, press the MODE RC
button, and then press one of the RC buttons 1, 2, 3, 4 or 5 to switch to a different video
output mode (see "Quick Setting of Video Output Mode").
 To choose the language of the player menu, use “Setup / General / Interface language”
setting.
 Check here for updated versions of player firmware (which may improve player function-
ing and extend player possibilities): http://dune-hd.com/firmware/.
 Check here for more detailed and up-to-date documentation and information on player
usage: http://dune-hd.com/manuals/, http://dune-hd.com/support/.