Operation Manual
27
English
Slicer
5.1 General Operation
1. Press MODE repeatedly until < FM Radio > is displayed.
For initial use, it will start at the beginning of the FM frequency range (87.50MHz).
Otherwise, the last FM station listened to will be selected.
Note: or enter < Main menu >, and then turn SELECT to < FM >, press SELECT to conrm.
5.2 Scan Setting
P By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations.
P To change the scan settings so that they stop only at stations with good signal strength, press
MENU→< Scan setting > →Strong stations only? →Yes, press SELECT to conrm.
5.3 How to Scan
1. To manually adjust frequency, when the frequency shows up, press and hold MENU until it
says ‘Turn to tune’, and then turn SELECT to adjust it by 0.05MHz per step, or while the frequency is
displayed, press up/down on the remote control to adjust manually.
2. For auto-searching, when the frequency is displayed, simply press SELECT, or SCAN.
Chapter 5 - FM Mode