Operation Manual
38
English
10.5 Enter Setup Wizard
When this unit is started for the rst time, it runs through a setup wizard to congure settings for date/time and network.
Once this has nished, the system is ready to use in most modes.
1. To run the setup wizard again, press MENU→Main menu→ System settings
→ Setup wizard→ Yes.
2. Press SELECT to conrm ‘ Ye s ’, then step by step to set it.
For Power on condition:
Note: Here, high brightness level can make it easy to view the station information.
1. Press DIMMER directly to enter backlight level setting mode, when the cursor is pointing to ‘Power-On Level’, press
SELECT to conrm.
2. Turn SELECT to cycle through options: 0/1/2/3.
3. Press SELECT to conrm your preferred level to clearly view your radio information, setting to the high level is
recommended for power on condition.
For Standby condition:
The setting principle above is suitable for standby condition as well, setting to a low level is recommended if you feel
comfortable and you do not want the light bothering you.
10.6 Dimmer