Third Party Verification Claim

ManualsBrandsHDX ManualsAppliance partsFML-4 Premium Refrigerator Water Filter Replacement For LG LT800P (2-Pack)

1. Certied by NSF 2. Certied by IAPMO

THANK YOU

We appreciate the trust and conﬁdence you have placed in HDX through the purchase of this ﬁlter.

We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of

products available for your home improvement needs. Thank you for choosing HDX!

NOTE: Do not use with water that is microbiologically unsafe or of unknown water quality without

adequate disinfection before or after the system. Systems certied for cyst reduction may be used

with disinfected water that may contain lterable cysts.

Model FML-4

Item 1007435558

USE AND CARE GUIDE

ICE & WATER REFRIGERATOR FILTER

Safety Information

Pre-installation

Shut off the cold-water supply to the refrigerator before installation. Turn on the refrigerator

water dispenser to release water pressure, letting water drain from the pipe completely.

It is normal for black carbon nes (particles) to appear on the outside of your lter. This happens

when the lter is jarred in shipping. It is safe to simply wipe it off.

The lter connectors are larger to prevent leaks. You might have to twist the lter hard to make

sure the connection is secure.

Installation

Locate the lter cartridge holder in the back upper right hand corner of the refrigerator. To open

the cartridge cover, push in where indicated and the cover will drop down.

Remove old lter by slowly rotating it to the left. A small amount of water may drip down.

Position the cartridge inside the cartridge holder and slowly rotate the cartridge to the right until

it stops. When the cartridge is properly installed, you will feel it “click” as it locks into place. Do

not over tighten.

Close the cartridge cover.

Tested and Certied by NSF International against NSF/ANSI Standards 42, 53 and 401

in model FML-4 for the reduction of the claims specied on the Performance Data Sheet,

and to NSF/ANSI 372 (≤0.25% lead).

LG® systems: Press and hold the reset button for 3 seconds.

Kenmore® systems: The lter reset for Kenmore refrigerators varies by model. See the documen-

tation that came with your refrigerator.

LG® ﬁlters

LT800P®, LT800PC, LT800PCS, ADQ73613401, ADQ73613401-S, ADQ73613402-S, ADQ73613403,

ADQ73613407, ADQ32617801, ADQ32617703, ADQ72910901, ADQ73613408, ADQ75795104

Kenmore® ﬁlters

9490, 46-9490, 469490, 4609490000, ADQ736134102

A replacement for the following water lters:

Operating Temperature: 33°F -100°F/0.6°C - 38°C

Working Pressure: 20 psi -100 psi/140 kPa - 689 kPa

Rated Capacity: 200 gallons/757 litres

Flow Rate: 0.5 gpm/1.9 Ipm

Operating specications:

The system has been tested and certiﬁed by the NSF International and IAPMO R&T according to

NSF/ANSI Standards 42, 53, and 401 for the reduction of the substances listed below.

The concentration of the indicated substances in water entering the system was reduced to a concen-

tration less than or equal to the permissible limit for the water leaving the system, as speciﬁed by

NSF/ANSI Standards 42, 53, and 401. While testing was performed under standard laboratory

conditions, actual performance may vary.

Substance reduction:

NOTE: These are the most common lter reset instructions. If the instructions don’t work for

your refrigerator brand, see the documentation that came with your refrigerator.

Speciﬁcations

LG® is a registered trademark of LG CORP.

LG® is used for reference purposes only.

Kenmore® is a registered trademark of KCD IP, LLC.

Kenmore® is used for reference purposes only.

WARNING: To reduce the risk of property damage due to water leakage, this lter MUST be

installed in accordance with the manufacturer's specications and instructions. This lter unit

must be replaced every 200 gallons or 6 months. Failure to follow instructions and operating

specications will void your warranty. Further, manufacturer assumes no responsibility or

liability for damages arising out of misuse of the product.

1 2 3 4

Q: Why is it difcult to twist the new lter into the lter housing?

A: The connector may expand because of water pressure. Therefore, it is recommended you push the

new ﬁlter in with a little bit of force, but not too hard. Then turn it clockwise.

Q: Do I need to ush the lter after installation?

A: After installation, it is highly recommended you run water for a few minutes before using. Water

ﬁlters are made from advanced coconut carbon block, so there are some carbon ﬁnes in the ﬁlter.

Flushing removes the carbon ﬁnes to produce clean water.

Q: Must the lter be changed every 6 months?

A: Yes, you must replace the ﬁlter every six months or sooner if water ﬂow is reduced or if there is

heavy sediment / rust present. Over-used ﬁlters will degrade the ﬁltration performance.

Troubleshooting

Storage and Maintenance

Replace your lter every 6 months or 200 gallons to prevent bacteria and fungus growth in your

lter, supply lines, and storage tank.

Keep your unused lters in a cool, dark, and dry place until you need them.

If you do not use your water dispenser for more than four days, run two gallons of water before

using it to prevent bad tasting water.

Run water from the dispenser for 5 minutes at 0.5 gpm (about 2.5 gallons) to clear the system

and prevent sputtering.

Resetting your lter indicator:

Certied by IAPMO R&T against NSF/ANSI 53 and 401 in Model FML-4 for the contaminants

listed in performance data sheet.

Substance

Inﬂuent Challenge

Concentration

Percent

Reduction

Product Water

Concentration

U.S. EPA Level/NSF Maximum Permissible

Product Water Concentration

Chlorine¹

Taste and Odor¹

2.1 mg/L

97.0% 0.063 mg/L ≥50%

NSF/ANSI Standard 42 – Aesthetic Effects

Substance

Inﬂuent Challenge

Concentration

Percent

Reduction

Product Water

Concentration

U.S. EPA Level/NSF Maximum Permissible

Product Water Concentration

Substance

Inﬂuent Challenge

Concentration

Percent

Reduction

Product Water

Concentration

U.S. EPA Level/NSF Maximum Permissible

Product Water Concentration

NSF/ANSI Standard 53 – Health Effects

NSF/ANSI Standard 401 – Emerging Compounds / Incidental Contaminants

Benzene² 15 ug/L 96.6% 0.5 ug/L 0.5 ug/L

Carbofuran²

73 ug/L

98.4%

2 ug/L 40 ug/L

Lead (pH 8.5)²

140 ug/L

99.6%

0.5 ug/L

10 ug/L

Lead (pH 6.5)²

99.6%

MTBE²

0.015 mg/L

98.64%

0.0002 mg/L 0.005 mg/L

0.003 mg/LAtrazine²

0.009 mg/L

0.989

0.0001 mg/L

Cyst²

120,000 oocysts/L

1 oocysts/L

Endrin²

6 ug/L

93.6%

0.3 ug/L 2 ug/L

2 ug/L

Mercury (pH 8.5)²

Mercury (pH 6.5)²

92.3%

0.5 ug/L

93.8%

0.3 ug/L

1,2,4 -Trichlorobenzene²

0.21 mg/L

0.005 mg/L

0.003 mg/L

0.07 mg

p-dichlorobenzene²

0.225 mg/L

0.075 mg/L

Tetrachloroethylene²

0.015 mg/L

0.9935

0.0001 mg/L 0.005 mg/L

o-Dichlorobenzene²

1.8 mg/L

0.9999

0.0002 mg/L

0.0005 mg/L

0.0086 mg/L

0.00042 mg/L

0.6 mg/L

Carbon Tetrachloride²

0.015 mg/L

0.9664

0.005 mg/L

2.1 mg/L

0.9959

0.7 mg/L

0.21 mg/L

0.998

0.07 mg/L

0.015 mg/L

0.9787

0.0003 mg/L 0.003 mg/L

Ethylbenzene²

2,4-D²

Toxaphene²

Lindane²

0.002 mg/L

0.9527

0.0001 mg/L 0.0002 mg/L

＞99.99%

≥99.95%

＞97.7%

＞98.6%

Phenytoin² 0.21 ug/L 0.952

10 ng/

30 ng/L

Naproxen²

0.13 ug/L

96.2% 5 ng/L

5 ng/L

20 ng/L

Estrone²

0.15 ug/L

96.6%

Bisphenol A²

2.5 ug/L

99.2%

20 ng/L 300 ng/L

Nonyl phenol²

1.8 ug/L

97.2%

50 ng/L

200 ng/L

Trimethoprim²

140 ng/L

1.4 ng/L

20 ng/L

Carbamazepine²

1400 ng/L

14 ng/L

200 ng/L

Atenolol²

200 ng/L

2 ng/L

30 ng/L

Meprobamate²

400 ng/L

4 ng/L

60 ng/L

DEET²

1400 ng/L

140 ng/L

0.9691

44 ng/L

200 ng/L

Metolachlor² 14 ng/L

200 ng/L

Linuron²

1.4 ng/L

20 ng/L

TCEP²

5000 ng/L

0.9784

108 ng/L

700 ng/L

TCPP² 0.9625

188 ng/L

Ibuprofen²

0.42 ug/L

94.4%

22 ng/L

60 ng/L

＞99%



HDX

warrants to the consumer that for the period of ninety (90) days from the date of purchase, the HDXTM

Water Filter Pitcher, when used strictly in accordance with instructions. has the effects on municipally treated,

potable tap water described in the enclosed literature. During this 90-day period, if you discover that any parts

of the pitcher are damaged or broken due to manufacturing defects, we will replace the parts free of charge. Call

our Customer Service Team at Altanta, GA at 1-800-514-6729.

Questions, problems, missing parts? Before returning to the store,

call HDX Customer Service

8 a.m - 7 p.m., EST, Monday-Friday, 9 a.m. - 6 p.m., EST, Saturday

1-800-514-6729

HOMEDEPOT.COM/HDX

Warranty

Summary of content (2 pages)

PAGE 1
Item 1007435558 Model FML-4 Safety Information Tested and Certified by NSF International against NSF/ANSI Standards 42, 53 and 401 in model FML-4 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (≤0.25% lead). Certified by IAPMO R&T against NSF/ANSI 53 and 401 in Model FML-4 for the contaminants listed in performance data sheet. Pre-installation Shut off the cold-water supply to the refrigerator before installation.
PAGE 2
Item 1007435558 Modelo FML-4 Información de seguridad NOTA: Estas son las instrucciones más comunes para restablecer el filtro. Si las instrucciones no funcionan para la marca de su refrigerador, consulte la documentación que acompaña a su refrigerador. Probado y certificado por NSF International conforme a las normas NSF/ANSI 42, 53 y 401 en el modelo FMS-1 para la reducción de las demandas especificadas en la Hoja de Datos de Rendimiento, y según NSF/ANSI 372 (≤0,25% de plomo).