Third Party Verification Claim

ManualsBrandsHDX ManualsAppliance partsHDX FMS-1 Premium Refrigerator Water Filter Replacement For Samsung HAF-CU1S / DA29-00003G (2-Pack)

THANK YOU

We appreciate the trust and conﬁdence you have placed in HDX through the purchase of this ﬁlter.

We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of

products available for your home improvement needs. Thank you for choosing HDX!

Q: Why is it difcult to twist the new lter into the lter housing?

A: The connector may expand because of water pressure. Therefore, it is recommended you push the

new ﬁlter in with a little bit of force, but not too hard. Then turn it clockwise.

Q: Do I need to ush the lter after installation?

A: After installation, it is highly recommended you run water for a few minutes before using. Water

ﬁlters are made from advanced coconut carbon block, so there are some carbon ﬁnes in the ﬁlter.

Flushing removes the carbon ﬁnes to produce clean water.

Q: Must the lter be changed every 6 months?

A: Yes, you must replace the ﬁlter every six months or sooner if water ﬂow is reduced or if there is

heavy sediment / rust present. Over-used ﬁlters will degrade the ﬁltration performance.

HDX

warrants to the consumer that for the period of ninety (90) days from the date of purchase, the HDXTM

Water Filter Pitcher, when used strictly in accordance with instructions. has the effects on municipally treated,

potable tap water described in the enclosed literature. During this 90-day period, if you discover that any parts

of the pitcher are damaged or broken due to manufacturing defects, we will replace the parts free of charge. Call

our Customer Service Team at Altanta, GA at 1-800-514-6729.

NOTE: Do not use with water that is microbiologically unsafe or of unknown water quality without

adequate disinfection before or after the system. Systems certied for cyst reduction may be used

with disinfected water that may contain lterable cysts.

Questions, problems, missing parts? Before returning to the store,

call HDX Customer Service

8 a.m - 7 p.m., EST, Monday-Friday, 9 a.m. - 6 p.m., EST, Saturday

1-800-514-6729

HOMEDEPOT.COM/HDX

Model FMS-1

Item 1007435560

USE AND CARE GUIDE

ICE & WATER REFRIGERATOR FILTER

Safety Information

Pre-installation

Shut off the cold-water supply to the refrigerator before installation. Turn on the refrigerator

water dispenser to release water pressure, letting water drain from the pipe completely.

It is normal for black carbon nes (particles) to appear on the outside of your lter. This happens

when the lter is jarred in shipping. It is safe to simply wipe it off.

The lter connectors are larger to prevent leaks. You might have to twist the lter hard to make

sure the connection is secure.

Installation

Locate existing lter and remove it by turning it counter clockwise as shown in the graphic.

Holding the new lter in your hands, carefully remove the packaging and sanitary end-cap from

the new lter.

Apply slight upward pressure and rotate the lter clockwise. Ensure lter is fully installed in

refrigerator head a full 1/4 turn. This is required to activate the internal valve inside the refriger-

ator. If the lter is not turned a full 1/4, the valve will not fully open and may cause the water

ow to be slow, or even cause the valve to make a chattering noise during use.

Tested and Certied by NSF International against NSF/ANSI Standards 42, 53 and 401

in model FMS-1 for the reduction of the claims specied on the Performance Data Sheet,

and to NSF/ANSI 372 (≤0.25% lead).

The concentration of the indicated substances in water entering the system was reduced to a concen-

tration less than or equal to the permissible limit for the water leaving the system, as speciﬁed by

NSF/ANSI Standards 42, 53, and 401. While testing was performed under standard laboratory

conditions, actual performance may vary.

Check lter one more time for any leaks.

Run water from the dispenser for 5 minutes at 0.5 gpm (about 2.5 gallons) to clear the system

and prevent sputtering.

Samsung® ﬁlters

HAF-CU1S,HAF CU1, DA29-00003, DA29-00003A-B, DA29-00003G, DA29-00003A, DA29-00003B,

DA61-00159, DA61-00159A, DA61-00159A-B, TADA29-00003A, TADA29-00003

A replacement for the following water lters:

Operating Temperature: 33 -100°F/0.6 - 38°C

Working Pressure: 20 -100 psi/140 - 689 kPa

Rated Capacity: 300 gallons/1,137 litres

Flow Rate: 0.5 gpm/1.9 Ipm

Operating specications:

The system has been tested and certiﬁed by the NSF International and IAPMO R&T according to

NSF/ANSI Standards 42, 53, and 401 for the reduction of the substances listed below.

Substance reduction:

NOTE: Initial ow rate may be slower than expected. Full ow rate should be restored within

24-36 hours.

Speciﬁcations

Troubleshooting

Storage and Maintenance

Warranty

Dispense water into glass looking for good water ow. If ow is slow, remove and reinstall lter

ensuring that the lter is a full 1/4 turn.

Resetting your lter indicator: Press and hold the ICE TYPE and CHILD LOCK buttons for three

seconds. The water lter indicator should turn green.

Replace your lter every 6 months or 300 gallons to prevent bacteria and fungus growth in your

lter, supply lines, and storage tank.

Keep your unused lters in a cool, dark, and dry place until you need them.

If you do not use your water dispenser for more than four days, run two gallons of water before

using it to prevent bad tasting water.

Samsung® is a registered trademark of Samsung Electronics Co.,Ltd.

Samsung® is used for reference purposes only.

WARNING: This lter unit must be replaced every 300 gallons or 6 months.

To reduce the risk of property damage due to water leakage, this lter MUST be installed in

accordance with the manufacturer’s specications and instructions.

Failure to follow instructions and operating specications will void your warranty. Further,

manufacturer assumes no responsibility or liability for damages arising out of misuse of the

product.

1 2 3 4

Certied by IAPMO R&T against NSF/ANSI 53 and 401 in Model FMS-1 for the contaminants

listed in performance data sheet.

Substance

Inﬂuent Challenge

Concentration

Percent

Reduction

Product Water

Concentration

U.S. EPA Level/NSF Maximum Permissible

Product Water Concentration

Chlorine¹

Taste and Odor¹

2.1 mg/L

97.0% 0.063 mg/L ≥50%

NSF/ANSI Standard 42 – Aesthetic Effects

Substance

Inﬂuent Challenge

Concentration

Percent

Reduction

Product Water

Concentration

U.S. EPA Level/NSF Maximum Permissible

Product Water Concentration

Substance

Inﬂuent Challenge

Concentration

Percent

Reduction

Product Water

Concentration

U.S. EPA Level/NSF Maximum Permissible

Product Water Concentration

NSF/ANSI Standard 53 – Health Effects

NSF/ANSI Standard 401 – Emerging Compounds / Incidental Contaminants

Benzene² 15 ug/L 96.6% 0.5 ug/L 0.5 ug/L

Carbofuran²

73 ug/L

98.4%

2 ug/L 40 ug/L

Lead (pH 8.5)²

140 ug/L

99.6%

0.5 ug/L

10 ug/L

Lead (pH 6.5)²

99.6%

MTBE²

0.015 mg/L

98.64%

0.0002 mg/L 0.005 mg/L

0.003 mg/LAtrazine²

0.009 mg/L

0.989

0.0001 mg/L

Cyst²

120,000 oocysts/L

1 oocysts/L

Endrin²

6 ug/L

93.6%

0.3 ug/L 2 ug/L

2 ug/L

Mercury (pH 8.5)²

Mercury (pH 6.5)²

92.3%

0.5 ug/L

93.8%

0.3 ug/L

1,2,4 -Trichlorobenzene²

0.21 mg/L

0.005 mg/L

0.003 mg/L

0.07 mg

p-dichlorobenzene²

0.225 mg/L

0.075 mg/L

Tetrachloroethylene²

0.015 mg/L

0.9935

0.0001 mg/L 0.005 mg/L

o-Dichlorobenzene²

1.8 mg/L

0.9999

0.0002 mg/L

0.0005 mg/L

0.0086 mg/L

0.00042 mg/L

0.6 mg/L

Carbon Tetrachloride²

0.015 mg/L

0.9664

0.005 mg/L

2.1 mg/L

0.9959

0.7 mg/L

0.21 mg/L

0.998

0.07 mg/L

0.015 mg/L

0.9787

0.0003 mg/L 0.003 mg/L

Ethylbenzene²

2,4-D²

Toxaphene²

Lindane²

0.002 mg/L

0.9527

0.0001 mg/L 0.0002 mg/L

＞99.99%

≥99.95%

＞97.7%

＞98.6%

Phenytoin² 0.21 ug/L 0.952

10 ng/

30 ng/L

Naproxen²

0.13 ug/L

96.2% 5 ng/L

5 ng/L

20 ng/L

Estrone²

0.15 ug/L

96.6%

Bisphenol A²

2.5 ug/L

99.2%

20 ng/L 300 ng/L

Nonyl phenol²

1.8 ug/L

97.2%

50 ng/L

200 ng/L

Trimethoprim²

140 ng/L

1.4 ng/L

20 ng/L

Carbamazepine²

1400 ng/L

14 ng/L

200 ng/L

Atenolol²

200 ng/L

2 ng/L

30 ng/L

Meprobamate²

400 ng/L

4 ng/L

60 ng/L

DEET²

1400 ng/L

140 ng/L

0.9691

44 ng/L

200 ng/L

Metolachlor² 14 ng/L

200 ng/L

Linuron²

1.4 ng/L

20 ng/L

TCEP²

5000 ng/L

0.9784

108 ng/L

700 ng/L

TCPP² 0.9625

188 ng/L

Ibuprofen²

0.42 ug/L

94.4%

22 ng/L

60 ng/L

＞99%

1. Certied by NSF 2. Certied by IAPMO



Summary of content (2 pages)

PAGE 1
Item 1007435560 Model FMS-1 Safety Information Tested and Certified by NSF International against NSF/ANSI Standards 42, 53 and 401 in model FMS-1 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (≤0.25% lead). USE AND CARE GUIDE ICE & WATER REFRIGERATOR FILTER NOTE: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hours.
PAGE 2
Item 1007435560 Modelo FMS-1 Información de seguridad NOTA: El flujo inicial puede ser más lento de lo esperado. El flujo total debería restablecerse en 24-36 horas. Probado y certificado por NSF International conforme a las normas NSF/ANSI 42, 53 y 401 en el modelo FMS-1 para la reducción de las demandas especificadas en la Hoja de Datos de Rendimiento, y según NSF/ANSI 372 (≤0,25% de plomo).