Use and Care Manual

Safety Information(Continued)
AIR SUPPLY AND CONNECTIONS
The Connector on the tool must not hold pressur e when air supply is disconnected. If an incorr ect fitting is used, the tool can remain charged with air after disconnecting and thus will be able to drive a fastener even after the air line is disconnected, possible causing injury . Do not use any type of reactive gases, including, but not limited to, oxygen and combustible gases, as a power source. Use filtered, lubricated, r egulated compressed air only. Use of a reactive gas instead of compressed air may cause the tool to explode which will cause death or serious personal injury . Use only a pressure-r egulated compressed air source to limit the air pr essure supplied to the tool. The regulated pressur e must not exceed 110 psi. If the regulator fails, the pr essure delivered to the tool must not exceed 200psi. Over pressurizing the tool is able to result in bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compr essed air at the rated pressur e or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressur e or within the rated air -pr essur e range. Always disconnect air source:
1. 2.
3. 4.
Before unloading or making adjustments. When maintaining the tool. When clearing a jam.
When touching the safety yoke.
When tool is not in use. When moving to a different work ar ea.
Warranty
6
7
LO ADING TOOL
Do not load the tool with fasteners when any one of the operating contr ols is activated. Never place a hand or any part of body in fastener discharge ar ea of tool. Never point tool at anyone. Do not pull the trigger or depress the workpiece contact as accidental actuation may occur, possibly causing injury.
1. 4. 2. 3.
WARNING: The warnings and precautions discussed above cannot cover all possible conditions and situations that may occur It must be understood by the user that common sense and caution are factors which cannot be built into this product but must be supplied by the user
.
,
.
Such precautionary measures reduce the risk of injury to persons.
This warranty covers defects in workmanship or materials in this HDX pneumatic nailer kit for the one-year period from the date
f pur chase. This warranty is specific to this pneumatic nailer kit. W arranties for other HDX products may vary .
This warranty applies only to the original retail purchaser and may not be transferr ed. This warranty does not cover normal wear and tear or any malfunction, failure or defect resulting from misuse, abuse, neglect, alteration, modification or repair by other than a service center authorized to repair branded air nailer. Expendable materials, such as O-rings, bumpers, driver blades, seals, etc. are not covered by this warranty. This warranty does not apply to used in industrial application or for rental purposes. makes no warranties, representations or promises as to the quality or performance of its
other than those specifically stated in this warranty.
HDX
pneumatic nailer kit
HDX
pneumatic nailer kit o
HDX PNEUMA TIC NAILER KIT LIMITED ONE-YEAR W ARRANTY ADDITIONAL LIMIT ATIONS
To the extent permitted by applicable law , all implied warranties, including warranties of merchantability or fitness for a particular purpose, are disclaimed. Any implied warranties, including warranties of merchantability or fitness for a particular purpose, that can not be disclaimed under state law are limited to one year from the date of purchase. HDX is not responsible for direct, indirect, incidental, special or consequential damages. If this is used for commercial purposes, the warranty will apply for ninety (90) days from the date of purchase. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
pneumatic nailer kit
1. 4. 2. 3. 5.
This tool kit has been shipped completely assembled Carefully remove the tool and any accessories from the box Inspect the tool carefully to make sure no breakage or damage occurred during shipping Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool If any parts are damaged or missing please call 1-800-514-6729
.
.
.
.
,
WARNING: If any parts are missing, do not operate the tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury .
Unpacking
WARNING: Do not attempt to modify the tool or create accessories not recommended for use with the tool. Any such alteration or modification is misuse and could result in hazardous condition leading to possible serious personal injury .
HOMEDEPOT.COM
Please contact 1-800-514-6729 for further assistance.