Use and Care Manual

3 HOMEDEPOT.COM
Please contact 1-800-514-6729 for further assistance.
Warranty
1 YEAR LIMITED WARRANTY
WHAT IS COVERED
If within one year from the date of purchase, this HDX air tool product fails due to a defect in materials or workmanship, immediately
contact the Customer Service Team at 1-800-514-6729. Do not return the air tool to the store. Please be prepared to send the product,
postage prepaid, to the address provided by the Customer Service Team. The package must also include a copy of the dated first owner
purchase receipt with the air tool model included and circled. The month/year of manufacture of the air tool must also be included to
determine warranty. A defective product will be promptly replaced with a new one of equal or greater value. This warranty gives you
specific rights, and you may also have other rights, which vary from state to state.
WHAT IS NOT COVERED
This warranty excludes incidental/consequential damages and failures due to misuse, abuse, or normal wear and tear. To the extent
permitted by applicable law, all implied warranties, including warranties of merchantability or fitness for a particular purpose, are
disclaimed. Any implied warranties, including warranties or merchantability or fitness for a particular purpose, that cannot be disclaimed
under state law are limited to one year from the date of purchase. HDX is not responsible for direct, indirect, incidental, special, or
consequential damages. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitations may not apply to you.
Contact the Customer Service Team at 1-800-514-6729 or visit www.HomeDepot.com.
Pre-Operation
SPECIFICATIONS
Maximum RPM 20,000 RPM at 90 PSI
Maximum Air Pressure 90 PSI
Air Consumption 3.0 CFM @ 90 PSI
Air Inlet Diameter 1/4 in. - 18 NPT (female inlet)
Spindle Diameter 3/8 in.
Overall Dimensions 3-3/8 in. D X 7-3/8 in. L X 3-3/8 in. H
Weight 1.6 lbs.
RECOMMENDED SETUP FOR PNEUMATIC TOOLS
NOTE: When connecting to the air supply: Prior to
each use, if an automatic oiler is not used, add two
drops of air tool oil (not included) into the air inlet
fitting of the cut-off tool. Add a few more drops after
each hour of continual use. An oiler, regulator, and
inline filter should be incorporated into the air system
for best results.
Air Compressor
Air Valve
Air Tool
Filter
Regulator
Oiler