User Manual

26
Looper
The HeadRush Pedalboard has a built-in looper that you can use to layer your performances. While the looper’s
operation is shown in the display, you can control most of it conveniently with the footswitches.
The looper can hold up to 20 minutes of audio at a time across a maximum of 100 layers.
To record the first layer of a loop, press the Record footswitch. Recording will begin immediately and the
footswitch indicator will light red. Press the Record footswitch again to stop recording and start loop playback.
The footswitch is now called Overdub and the footswitch indicator is yellow.
To record additional layers onto the loop (overdub), press the Overdub footswitch. Overdubbing will begin
immediately and the footswitch indicator will light red. Press the Overdub footswitch again to stop overdubbing
and continue playback.
To erase the top-most (last-added) layer of the loop, press the Peel footswitch. The top-most layer of the loop
will be erased immediately. This process is destructive, so you can’t re-add it later.
To record over a section of the top-most (last-added) layer (like a punch-in/punch-out function), press the
Insert footswitch. Recording will begin immediately and the footswitch indicator will light red. Press the Insert
footswitch again to stop recording and continue playback. This overwrites that section of the top-most layer.
To halve or double the length of the loop, press the 1/2 Loop or 2X Loop footswitch, respectively. The loop’s
relative length is shown in the Loop Length field. The halving process is non-destructive, so you can restore your
original loop and its content by pressing 2X Loop.
Rig name.
This controls how much
of the looper’s signal you
hear in the outputs.
This controls how much
of the looper’s signal is
routed back through it
when recording another
layer.
This meter indicates
your current
location in the loop
during recording or
playback.
This indicates the
current speed of the
loop as a multiple or
fraction of the
original.
This indicates the length
of the current loop.
This indicates how many layers are playing in the
current loop, including the original.
This indicates the direction
of playback.
This indicates whether the looper is
located before (Pre) or after (Post) your
signal chain. Moving the looper to the
Pre position enables you to edit your
rig without having to play the same riff
over and over again.