User Manual

Global Settings

Use the global settings to configure the HeadRush Pedalboard’s overall operation.

To show the global settings, tap the  button in the upper-right corner of the screen, and tap Global Settings.

To select each page of the global settings, tap 1 or 2 at the bottom edge of the screen.

LCD Brightness: This setting determines the brightness of the main display. Tap this field, turn the encoder to

select 1 (dim) through 5 (bright), and then press the encoder.

Audio Configuration:

Rig Input: This setting determines whether each rig’s input signal is taken from the guitar input (Guitar) or the

right (R) return input (FX Ret R). When set to Per Rig, the source is determined by the Rig Input setting of

each rig (see Adjusting Settings > Parameters > In to learn about this). When set to FX Ret R or Per Rig, the

FX-Loop Stereo Return setting will be disabled; the signal will be mono.

FX-Loop Stereo: These settings determine whether the incoming and outgoing signal in the effects loop is

stereo or mono. Tap Send to enable or disable the stereo signal for the send outputs. Tap Return to enable

or disable the stereo signal for the return inputs.

Alternate Output: These settings determine the signal sent from each output.

Source: This setting determines the point in the signal path from which the alternate output signal is taken:

Rig Input, Amp Input (the default setting), Amp Output, Cab Input, Cab Output, IR Input, Amp 2 Input,

Amp 2 Output, Cab 2 Input, Cab 2 Output, or IR 2 Input.

XLR Out: This setting determines whether the XLR outputs will send the rig output signal (Rig) or alternate

output signal (Alt).

Amp/Line Out: This setting determines whether the 1/4

” (6.35 mm) outputs will send the rig output signal

(Rig) or alternate output signal (Alt).

Phones Out: This setting determines whether the phones output will send the rig output signal (Rig) or

alternate output signal (Alt).