User Manual

USB Audio Settings:

Important note for Windows users: Before connecting the Headrush Gigboard to your computer, download and

install the necessary drivers from headrushfx.com/support.

Sample Rate: This setting determines the sample rate of the USB audio signal: 44.1 kHz, 48.0 kHz or 96.0 kHz.

Remember to select the same sample rate as the one in your DAW. Also, set it before opening your DAW.

USB Audio: This setting determines whether or not HeadRush Gigboard is sending a USB audio signal over a

USB connection. Tap On to enable sending of the USB audio signal with the selected Sample Rate. Tap

Off to disable the USB audio signal. (To change the Sample Rate, set USB Audio to Off first, select the

correct sample rate, set USB Audio to On again, and restart your DAW.)

USB Mode: This setting determines how the HeadRush Gigboard sends its audio signal over the USB

connection and how its outputs function while doing so:

• Live: The audio signal will be sent to your computer as well as to the HeadRush Gigboard’s outputs.

• DAW: The audio signal will be sent to your computer only. The HeadRush Gigboard’s outputs will be

disabled to prevent any latency while monitoring.

• Reamp: Your computer will send an audio signal to the HeadRush Gigboard, which will process it

through the current rig and send it back to your computer. The HeadRush Gigboard’s outputs will be

disabled to prevent any latency while monitoring

MIDI Settings: These settings determine how the HeadRush Gigboard sends and receives MIDI information to

and from external devices. These settings affect only the HeadRush Gigboard’s MIDI input or MIDI output.

MIDI Thru: Tap On to use the MIDI output as a MIDI throughput; any MIDI information sent to the HeadRush

Gigboard’s MIDI input will be sent directly to the MIDI output. Tap Off to use the HeadRush Gigboard’s

MIDI output normally; the HeadRush Gigboard will be able to send its own MIDI information out of the MIDI

output.

Recv MIDI Clock: Tap On to enable the HeadRush Gigboard to receive MIDI clock information. Tap Off to

use the HeadRush Gigboard’s own internal MIDI clock (which will not be sent out).

Prog Change: Tap Send to enable or disable the HeadRush Gigboard’s transmission of MIDI program change

messages when you load a rig. Tap Recv to enable or disable the HeadRush Gigboard’s reception of MIDI

program change messages from an external MIDI device.

MIDI Channel: This setting determines the MIDI channel(s) that the HeadRush Gigboard will send and receive

MIDI messages. Tap this field, turn the encoder to select all channels (Omni), or 1–16, and then press the

encoder.

Reminders:

Confirm Unsaved: This setting determines whether or

not you will see a confirmation message if you change

the rig while there are unsaved changes on the current

one. Tap On to enable these messages or Off to

disable them.

Alternatively, tap Do not show this dialog again in the

message itself to disable them.