User Manual

39
Global Settings
Use the global settings to configure the HeadRush Looperboard’s overall operation and all of your
loops.
To show the global settings, tap the  button in the upper-right corner of the screen, and tap
Global Settings.
To select each page of the global settings, tap the number at the bottom edge of the screen.
Storage Limit: This meter shows the amount of remaining internal recording time is available on
HeadRush Looperboard. If you are running out of internal space, you connect a USB Flash Drive or
SD Card for additional storage of loops. See Exporting and Importing Loops to learn more.
General:
Start/Stop All: This setting determines what happens after you use the Start/Stop All footswitch
to stop all of your tracks and then press it again. When set to Return, all tracks will start at the
beginning of the loop. When set to Pause, all tracks will restart from where you initially hit the
Start/Stop All footswitch to stop all tracks.
Note: This parameter only applies when using Fixed, Serial or Free Track Modes.
After Record: This setting determines what HeadRush Looperboard will do after an initial layer
is recorded on a looper track. When set to Play, the looper track will begin playback after the
initial layer is recorded. When set to Overdub, the looper track will immediately start
overdubbing after the initial layer is recorded.
After Bounce: This setting determines what happens to source tracks after they are bounced.
Select Delete to clear tracks after bouncing, or select Keep to have them remain.
Fixed Mode Recording: This setting determines how looper track playback is triggered after all
tracks have been stopped. When set to All, pressing a •Rec/Play/Dub footswitch for one track
will cause that track to begin recording or overdubbing and all other looper tracks to play back.
When set to Solo, pressing a •Rec/Play/Dub footswitch for a track will cause only that track to
begin recording or overdubbing.