User Manual

40
Start Up:
Default Setup On Start: This setting determines the default audio routing setup that is loaded
each time HeadRush Looperboard is powered on. When set to On, the factory default audio
routing setting will be loaded. When set to Off, the previous audio routing setting from your last
session with HeadRush Looperboard will be loaded.
Hold Function: These settings determine the function of the •Rec/Play/Dub and •Stop/–Undo
footswitches when held for more than 1.5 seconds.
Rec/Play/Dub: When set to Peel, holding a •Rec/Play/Dub footswitch will peel off the last
recorded layer. When set to Clear, holding a •Rec/Play/Dub footswitch will clear the looper
track.
Start/Stop: When set to Undo, holding a •Stop/–Undo footswitch will undo everything recorded
since you last pressed the •Rec/Play/Dub footswitch. Hold the •Stop/–Undo footswitch for 1.5
seconds again to re-do everything you recorded that was removed. When set to Clear, holding
a •Stop/–Undo footswitch will clear the looper track.
FX Edit Page:
Parameter Columns: This setting determines the number of parameter columns shown when
editing an FX Rack. Select 1, 2 or 3.